- ページ 9

洗濯機 Ariston S1200AUKのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ariston S1200AUK 13 ページ。 Ariston washing machine instruction s1200uk, s1200auk

ページを印刷する

Fig. 1

Trouble shooting

If the machine does not seem to be working properly before

calling the service engineer there are a number of things

you can check. Perhaps you have forgotten to push in a

button or you are not using the machine properly.

Machine won't start

Make sure:

the appliance is plugged to the mains socket; you have

electricity in your home, the door is firmly shut, the ON/OFF

button G is on I, the programming cycle knob, in washers

which have one, is on O, the programme is properly set and

the mains water tap is open.

Machine won't fill

Make sure:

the water tap is open and connected correctly to the hose;

the water mains has not been cut off and that water pressure

is sufficient; also check the hose for kinks.

Water is pumping in and out all the time

Make sure:

there are no kinks in the drain pipe and that it is at least at a

height of 60-100 cm; the pipe mouth is not below water

level and that the wall drain has no air outlet. If the problems

continue even after you have checked these points, shut

the water tap and turn off your washer.

Problems with pumping out water or

spinning

Make sure:

the programme selected has a draining cycle; the non

creasing "hydropstop" button, on washers which have one,

has not been pressed accidentally; the drainage pump is not

jammed; the drain pipe is bent; the drainage piping is

plugged; any drainage pipe extensions are properly

connected and do not prevent water flow.

Fig. 2

Removing limescale

Water contains increasing amounts of limescale because of

pollution. If you live in a hard water area in addition to

using water-softener in each wash, it is a good idea to put

the machine through a cycle without laundry or detergent,

just using limescale remover.

Lots of vibration during the spin

Make sure:

the internal oscillating unit was released correctly at the time

of installation (see installation instructions); the washer is

levelled correctly or too tightly fitted between furniture units

and the wall.

Your washer is leaking.

Make sure:

the ring nut of the supply pipe is firmly tightened; the

detergent dispenser is not plugged and the drainage pipe is

firmly fixed.

Excessive formation of suds.

Make sure:

the type of detergent you have used - is it suitable for an

automati washer - have you used too much detergent?

If despite all this your washer is still not running properly, call

your local Authorized Service Centre providing the

following information:

fault

model code (Mod. ....)

and serial number (S/N ....)

shown on the data plate at the back of your washer.

Never use the services of an unauthorised servicing technician

and insist on the use of original spare parts.