- ページ 4

スピーカーシステム Pioneer PDP-S06-LRのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer PDP-S06-LR 21 ページ。 Pioneer corporation operating instructions speaker system pdp-s06-lr

ページを印刷する

English

CONNECTION TO A PLASMA

DISPLAY

1 Switch off the power of the plasma display.

2 Connect the input terminals of the speaker system and

the speaker output terminals of the plasma display with

the accessory speaker cable. The polarity of the input

terminals is plus ª for the red terminal (the terminal on

the right side in the following figure) and minus · for

the black terminal (the terminal on the left side in the

following figure).

1. Remove the insulation

and twist the core ends

together.

· terminal

To the· terminal

(Speaker output terminals of the plasma display)

÷ After connection to the terminals, pull lightly on the cable

to confirm that the tips of the cable are connected posi-

tively to the terminals. An imperfect connection can cause

sound interruptions and noise.

÷ When cable cores stick out and ª and · lines are short-

circuited, an excessive load will be applied to the plasma

display and the operation will stop or trouble will be

caused.

÷ When the polarity is reversed for one speaker (left or right)

at the time of connection to the plasma display, the bass

reproduction will be reduced, the sound positioning will

be lost, and a correct stereo effect will not be obtained.

2. Push the lever, insert the

cable into the hole, and

release the lever.

ª terminal

To the ª terminal

CABINET MAINTENANCE

÷ Use a polishing cloth or dry cloth to wipe off dust and

dirt.

÷ When the cabinet is very dirty, wipe with a soft cloth

moistened with water-diluted cleanser; then wipe again

with a dry cloth. Do not use furniture wax or cleaners.

They may damage the surface of the cabinet.

÷ Never use thinner, benzine, insecticide sprays and other

chemicals on or near the cabinets, since these will cor-

rode the surfaces.

÷ When a chemical cloth is used, read the cautions for the

chemical cloth carefully.

SPECIFICATIONS

Cabinet : Enclosed type, antimagnetic design

Used speakers (two-way system) :

Woofer (for low tones) .............................. Oval cone type

Tweeter (for high tones) ...................... 2.5 cm dome type

Nominal impedance ..................................................... 8

Frequency Range ..................................... 50 to 20,000 Hz

Sensitivity ................................ 82 dB/W (at 1 m distance)

Permissible input :

Max. input ................................................................. 12 W

Rated input ................................................................ 4 W

Crossover frequency ................................................ 3 kHz

External Dimensions ....... 74 (W) x 714 (H) x 101 (D) mm

Weight ..................................................................... 1.7 kg

Accessory parts (for 2 speakers)

.............................................................. Speaker cable x 2

...................................... Flat countersunk head screw x 4

....................................... Hexagon socket head screw x 4

.............................................................. Mounting tool x 1

............... Speaker mounting fittings (for top left side) x 1

............. Speaker mounting fittings (for top right side) x 1

....................... Speaker mounting fittings (for bottom) x 2

................................................ Operating Instructions x 1

NOTE:

Specifications and design subject to possible modification

without notice, due to improvements.

Published by Pioneer Corporation.