- ページ 4
スピーカーシステム Pioneer PDP-S34-LRのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer PDP-S34-LR 20 ページ。
Pioneer PDP-S34-LR にも： サービスマニュアル (9 ページ)
ページを印刷する
English
CAUTION
When the display is to be moved after speaker
installation, do not hold the display by the speakers.
Do not hold the speakers and raise the display. This
may cause the deformation or damage of products.
4
CONNECTION TO A PLASMA
DISPLAY
1 Connecting the speaker cables
Before connecting the speaker cables, unplug the Plasma
Display from the power outlet. After you have finished
connecting up, plug the unit back into the power outlet.
Connect the input terminals of the speaker system and
the speaker output terminals of the Plasma Display with
the accessory speaker cables. Make sure the positive (ª)
and negative (·) terminals match when connecting.
1. Push the lever, insert the cable into the hole, and release
the lever.
· terminal (black) ª terminal (red)
White
To the· terminal
(Speaker input terminals of the speaker system)
2. For the output terminals on the Plasma Display, push the
lever, insert the cable into the hole, and release the lever.
ª · · ª
R
÷ After connection to the terminals, pull lightly on the cable
to confirm that the tips of the cable are properly con-
nected to the terminals. An imperfect connection can
cause sound interruptions and noise.
÷ When cable cores stick out and ª and · lines are short-
circuited, an excessive load will be applied to the Plasma
Display and the operation will stop or trouble will be
caused.
÷ When the polarity is reversed for one speaker (left or right)
at the time of connection to the Plasma Display, the bass
reproduction will be reduced, the sound positioning will
be lost, and a correct stereo effect will not be obtained.
÷ If you insert the speaker cable too far so that the insula-
tion is touching the speaker terminal, you may not get
any sound.
< right >
Input terminal of speaker
White with gray line
To the ª terminal
Output terminal of Plasma
Display
L
< wrong >