- ページ 12

スピーカーシステム Pioneer S-W110S-QLのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Pioneer S-W110S-QL 14 ページ。 Powered subwoofer
Pioneer S-W110S-QL にも：サービスマニュアル (20 ページ), 取扱説明書 (16 ページ)

ページを印刷する

TROUBLESHOOTING

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,

check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances

being used If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized

service center or your dealer to carry out repair work.

SYMPTOM

1 No power is being supplied

(Indicator does not light up when

power switch is turned on.)

2 No sound

(Indicator is lit.)

3 Sound is weak.

(LEVEL knob is turned up.)

4 Sound is distorted.

5 Howling noise occurs.

6 Much noise when listening to AM

or FM broadcasts.

SPECIFICATIONS

Cabinet ......................................................... Floor type system

Speaker (Magnetically shielded type) ........... 22 cm cone type

Power Amplifier Continuous Power Output (RMS)

S-W110S-QL/S-W110S-K ............... 110 W/4 Ω (30 – 200 Hz)

S-W150S ......................................... 150 W/4 Ω (30 – 200 Hz)

Above specifications are for when power supply is 230 V.

Input (sensitivity at 100 Hz/impedance)

SPEAKER LEVEL .................................. 2.0 V + 2.0 V/15 kΩ

LINE LEVEL (RCA jack) .................................... 200 mV/50 kΩ

Turnover Frequency .......... 50 – 200 Hz (continuously variable)

Outline Dimension

S-W110S-QL/S-W110S-K .... 250 (W) x 480 (H) x 475 (D) mm

S-W150S ......................... 280 (W) x 480 (H) x 495 (D) mm

Weight (without package)

S-W110S-QL/S-W110S-K ............................................ 14.2 kg

S-W150S ..................................................................... 19.7 kg

Power Requirements .......................... 220 – 230 V~, 50/60 Hz

Power Consumption

S-W110S-QL/S-W110S-K ............................................. 210 W

S-W150S ....................................................................... 300 W

Accessories ............................................... Speaker cords x 2

En/Fr

CAUSE

÷ Power supply plug is not correctly

inserted.

÷ Connection of speaker or accessory RCA

plug cord is wrong or disconnected.

÷ LEVEL knob is set to MIN.

÷ Polarity of the speaker cords (from the

amplifier or receiver to this unit) is

reversed.

÷ Level is too high.

÷ Input level is too high.

÷ Power supply to amplifier or speaker

switch is turned off.

÷ Subwoofer level is set too high.

÷ The AM loop antenna or the FM indoor

antenna is close to this unit.

(both channels in-phase)

RCA plug cord x 1

Operating instructions x 1

Warranty card x 1

÷ Insert plug securely.

÷ Check again and connect correctly.

÷ Turn clockwise slowly.

÷ Confirm the polarity of the wires and

connect them correctly.

÷ Turn the LEVEL knob counter-clockwise to lower the

level.

÷ Turn the amplifier's output level (volume, bass control,

bass boost) counter-clockwise to lower the level.

÷ Connect power supply to amplifier and turn

speaker switch on.

÷ Place the subwoofer a good distance from

speakers. Turn the LEVEL knob counter-

clockwise to lower the volume.

÷ Increase the distance between the AM or

FM antenna (for indoor use) and this unit.

NOTE:

Specifications and design subject to possible modification without

notice, due to improvements.

REMEDY

Published by Pioneer Corporation.