- ページ 11

スピーカーシステム Pioneer VSX-S300-kのPDF 操作方法をオンラインで閲覧またはダウンロードできます。Pioneer VSX-S300-k 36 ページ。 Audio/video multi-channel receiver
Pioneer VSX-S300-k にも：クイック・スタート・マニュアル (33 ページ)

ページを印刷する

Connecting your equipment

Bare wire connections

Front speaker terminals:

Twist exposed wire strands together.

Loosen terminal and insert exposed wire.

Tighten terminal.

10 mm

Other speaker terminals:

Twist exposed wire strands together.

Push open the tabs and insert exposed wire.

Release the tabs.

10 mm

CAUTION

• These speaker terminals carry HAZARDOUS LIVE

voltage. To prevent the risk of electric shock when

connecting or disconnecting the speaker cables,

disconnect the power cord before touching any

uninsulated parts.

• Make sure that all the bare speaker wire is twisted

together and inserted fully into the speaker terminal. If

any of the bare speaker wire touches the back panel it

may cause the power to cut off as a safety measure.

• Do not allow the speaker cable core to come into contact

with the receiver body.

If the speaker cable core comes into contact with any

metal portion of the receiver's body, it may damage the

speakers and cause smoke and fire.

Insert speaker cables securely into the terminals and

check that the cable does not come out of easily.

Connect the surround back or front height

speakers

Connect the PRE OUT SURR BACK/FRONT HEIGHT outputs

of the unit and additional amplifier to add a surround back or

front height speaker.

• The Pre Out setting must be set if the above connections

are performed. Select Surr.Back if the surround back

speaker is connected and Height if the front height

speaker is connected (If neither the surround back

speaker nor the front height speaker is connected, either

setting will suffice) (see The Pre Out Setting on page 30).

• You can use the additional amplifier on the surround back

channel pre-outs for a single speaker as well. In this case

plug the amplifier into the left (L (Single)) terminal only.

Switching the speaker terminal

Three speaker system settings are possible.

 Use SP-AB button to select a speaker terminal setting.

Press repeatedly to choose a speaker terminal option:

• SP:A ON – Sound is output from the speakers connected

to the A-speaker terminals and PRE OUT SURR BACK/

FRONT HEIGHT (multichannel playback is possible).

• SP:B ON – Sound is output from the two speakers connected

to the B-speaker terminals (only stereo playback is possible).

• SP:A+B ON – Sound is output from the A-speaker

terminals, the two speakers in the B-speaker terminals,

and the subwoofer. Multichannel sources are downmixed

only when the STEREO or STEREO ALC mode is selected

for stereo output from A- and B-speaker terminals.

• SP: OFF – No sound is output from the speakers.

Note

• Only SP:A ON and SP: OFF are available when the

Speaker System setting is set to Normal (see Speaker

System on page 27).

• The subwoofer output depends on the settings you made

in Speaker Setting on page 28. However, if SP:B ON is

selected above, no sound is heard from the subwoofer

(the LFE channel is not downmixed).

• All speaker terminals are switched off when headphones

are connected.

Making cable connections

Make sure not to bend the cables over the top of this unit (as

shown in the illustration). If this happens, the magnetic field

produced by the transformers in this unit may cause a

humming noise from the speakers.

Important

• Before making or changing connections, switch off the

power and disconnect the power cord from the AC outlet.

• Before unplugging the power cord, switch the power into

standby.

HDMI cables

Both video and sound signals can be transmitted

simultaneously with one cable. If connecting the player and the

TV via this receiver, for both connections, use HDMI cables.

H D M