- ページ 8

スクーター Cruza XR-300のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cruza XR-300 13 ページ。 Electric scooter

Fuse Installation

Your scooter comes with a 20amp fuse located inside the tool kit pouch. Locate the fuse

and insert it into the fuse holder located on the left side of the bike, under the foot plate.

Seat and Seat Post Installation

Insert the seat post into the bottom of the seat and tighten securely.

Next, insert the seat post into the post receiver that is already attached to the

footplate on the scooter and tighten the clamp securely.

Charging

Your scooter comes charged out of the carton. We still recommend charging the unit for

6-8 hours prior to it's first use. We also recommend charging your scooter after each use

and prior to storage.

WARNING: Do not allow your scooter to go into deep discharge, as this will damage the

batteries.

FIG 6

1. Make sure unit is turned off.

2. Open the charging socket cover

located on the right side of the

scooter frame, under the footplate.

(Fig. 5)

3. Locate your Battery Charger. (Fig.

Find the charger socket end

that has a three-prong socket and

plug it into the scooter.

4. Next, plug the AC plug into a wall

outlet.

When first plugged in, the charger has two

red lights that will illuminate at the same

time, indicating that the charging process

has started. Once the light on the charger

turns green, you may remove the charger

and close the safety cap.

Page8