- ページ 8

ウォーターヒーター Ariston 3626314のPDF 組立・取扱説明書をオンラインで閲覧またはダウンロードできます。Ariston 3626314 25 ページ。

This product is a device that must be installed vertically in order to operate correctly. Once installa-

tion is complete, and before any water is added or the power supply is connected, use a measuring

instrument (i.e. a spirit level) to check that the device has been installed perfectly vertical.

The appliance heats water to a temperature below boiling point. It must be linked up to a mains water

supply according to the appliance performance levels and capacity.

Before connecting the appliance, it is first necessary to:

- Check whether the characteristics (please refer to the data plate) meet the customer's requirements.

- Make sure the installation conforms to the IP degree (of protection against the penetration of liquids)

of the appliance according to the applicable norms in force.

- Read the instructions provided on the packaging label and on the appliance data plate.

This appliance was designed to be installed only inside buildings in compliance with the applicable

norms in force. Furthermore, installers are requested to keep to the following advice in the presence of:

- Humidity: do not install the appliance in closed (unventilated) and damp rooms.

- Frost: do not install the appliance in areas where the temperature may drop critically and there may be

a risk that ice may form.

- Sunlight: do not expose the appliance to direct sun rays, even in the presence of windows.

- Dust/vapours/gas: do not install the appliance in the presence of particularly dangerous substances

such as acidic vapours, dust or those saturated with gas.

- Electrical discharges: do not install the appliance directly on electrical supplies that aren't protected

against sudden voltage jumps.

In the case of walls made of bricks or perforated blocks, partition walls featuring limited static, or ma-

sonry different in some way from those stated, you first need to carry out a preliminary static check of

the supporting system. The wall-mounting fastening hooks must be designed to support a weight that is

three times higher than the weight of the water heater filled with water.

Fastening hooks with a diameter of at least 12 mm are recommended.

We recommend installing the appliance as close as possible to the delivery points to minimise heat loss

along the pipes. Local regulations may provide for restrictions on installation in bathrooms; observe any

regulatory minimum distances. To facilitate maintenance, make sure there is a clearance of at least 50

cm inside the enclosure for access to the electrical equipment.

Hydraulic connection

Connect the water heater's inlet and outlet with pipes or fittings that are able to withstand temperature

in excees of 90°C at a pressure exceeding that of the working pressure. Therefore, we advise against

the use of any materials which cannot resist such high temperatures.

The appliance must not be supplied with water of hardness less than 12°F, nor with especially hard water

(greater than 25°F); we recommend installing a water softener, properly calibrated and controlled - do

not allow the residual hardness to fall below 15°F.

Screw a "T" piece union to the water inlet pipe with the blue collar. On one side of the "T" piece union,

screw a tap for draining the appliance that can only be opened with the use of a tool.

On the other side of the "T" piece union screw the safety valve supplied.

INSTALLING NORMS (for the installer)

8 / EN