- ページ 10

ウォーターヒーター Ariston ARIER052C2X045NのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ariston ARIER052C2X045N 18 ページ。 Two element residential electric water heaters

ページを印刷する

H. Applications

Figure 4 - Piping Detail - NOTE: Drawing is meant to demonstrate system

piping concept. Heat traps are optional.

PIPING NOTES:

1. Minimum pipe size should match connection size. Upsize pipe

accordingly if greater flow is required.

2. A thermal expansion tank suitable for potable water must be

sized and installed within this piping system between the backflow

preventer and the cold water inlet.

3. All circulators should have an integral flow check.

4. Drains and check valve between unit and storage tank will assist in

purging air from system.

5. These drawings are meant to demonstrate system piping only. The

installer is responsible for all equipment and detailing required by

local codes. In Massachusetts, you must install a vacuum relief valve

per 248 CMR.

6. Mixing valve application is optional, but recommended to help

prevent scalding. See Part 3 for more information.

Part 4 - Wiring

Tank must be full of water before the power is turned on. Heating

elements will be damaged if energized for even a short time while

tank is dry. Failures due to "dry-firing" ARE NOT covered by warranty.

This unit is factory wired to a junction box on top of the water heater

for field wiring connection. These heaters are equipped and wired

for the maximum possible input allowable (see Table 3 for listing of

inputs and amperage requirements). The voltage requirement and

dedicated wattage load for the heater is specified on the rating label

of the water heater. Consult your local power company to determine if

your electrical service is adequate for the additional load of the heater.

ahl-631 Revision Date 2.14.22

Refer to the wiring diagrams for field connections. All wiring must

conform to local code and the National Electric Code, and should be

done by a qualified licensed electrician or the local electric utility.

Grounding can be accomplished by using approved conduit and

fittings or other approved conductive material. A grounding wire is

provided on the junction bracket. This grounding wire must be used

in the installation.

Be sure to ground the water heater. The preferred way to ground

is with rigid metal conduit between the main panel and the water

heater junction box with approved end fittings (check codes on

the use of flexible conduit). If making a separate ground, a green

ground wire is provided in the water heater junction box. Replace

the junction box cover and insulation after you have made the

wiring connections. Failure to follow these instructions could

result in property damage, severe personal injury, or death.

Figure 5 - Dual Element Model Wiring Detail, Staged Element Operation

- Green Wire for Grounding the Water Heater