- ページ 3

アクセサリー Aeotec MULTISENSOR 6のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aeotec MULTISENSOR 6 13 ページ。 Z-wave water and flood sensor
Aeotec MULTISENSOR 6 にも：ユーザーマニュアル (13 ページ), マニュアル (3 ページ), ユーザーマニュアル (8 ページ), マニュアル (10 ページ)

ページを印刷する

Multisensor 6 user guide : Aeotec Group

Keep product and batteries away from open ﬂames and extreme heat. Avoid direct sun light or heat exposure. Always

remove all batteries from products that are being stored and not used. Batteries may damage the appliance if they

leak. Do not use rechargeable batteries. Ensure correct polarity when inserting the batteries. Improper battery use

may damage the product.

Contains small parts; keep away from children.

Quick Start.

Set Up Your Power

MultiSensor 6 can be powered by battery or by USB with an appropriate adapter. For the purposes of installation and

setup, even if you intend to power your sensor with batteries, we recommend using the provided USB cable for

setup. For this, you'll need an adapter to plug your USB cable into; this can include any computer USB port and

most smartphone chargers. These steps can be performed in any location within your home, and not necessarily in

your MultiSensor 6's ﬁnal installation location.

For a USB powered installation:

1. Remove the battery cover by sliding the Unlock button and separating the two parts of your Sensor.

2. Insert the smaller end of the provided USB cable into your sensor's USB port.

3. Insert the larger end of the USB cable into a computer or adapter. Your MultiSensor 6 is now powered on.

4. Make sure to seat the Battery Cover back onto the MultiSensor 6 and lock it in.

For a battery powered installation:

1. Remove your sensor's rear cover as shown in the previous step.

2. Insert two CR123A batteries orientated according to the diagram within your sensor. Your MultiSensor 6 is now

powered on.

https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-

29-09-2020 17:00

Pagina 3 van 13