- ページ 5

ウォーターヒーター Ariston GL 4 SのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ariston GL 4 S 37 ページ。 Electric mini tank water heaters

General remarks

CAUTION

The manufacturer cannot be responsible for the damages caused by improper

installation or by failure to follow instructions in this manual. Comply with the

installation instructions before completing electric connection.

CAUTION

The GL 4 CA S model is only approved for installations in Canada.

The thermostat has been pre-set at the factory at a temperature:

CAUTION

- Equal or below 51.7°C (125° F) for GL 2.5 S, GL 4 S and GL 6+ S for USA with UL

certification (See fig. 2/4).

- Equal to 60°C (140° F) for GL 4 S for Canada with CSA certification. Check local codes

to see if the installation of a tempering valve is required (See fig. 2/5).

CAUTION

Hydrogen gas can be produced in a hot water system served by this heater that has not

been used for a long period of time (generally 2 weeks or more). Hydrogen gas is extremely

flammable. To reduce the risk of injury under these conditions, it is recommended that the

hot water faucet be opened for several minutes at the kitchen sink before using any

electrical appliance connected to the hot water system. If hydrogen gas is present, there

will probably be an unusual sound such as air escaping through the pipe as the water

begins to flow. There should be no smoking or open flame near the faucet at the time.

Any water heater should be installed in such a manner that if it should leak, the resulting

CAUTION

flow of water will not cause damage to the area in which it is installed. National Plumbing

codes require a drain pan for any water heater installation. Failure to install one is the sole

responsibility of owner and/or installer. Reference UPC 2000 (Uniform Plumbing Code)

Section 510- Protection from Damage or IPC 2000 (International Plumbing Code) Section

504- Safety Devices.

Installation instructions

MODEL GL 2.5 S - GL 4 S - GL 4 CA S - GL 6+ S

The GL 2.5 S, GL 4 S and GL 4 CA S water heaters can be installed under the sink.

Wall

Fasten the supplied mounting bracket to the wall. Use screws that are suitable for the

mounting

wall material and the weight of the heater. Hang the water heater on the bracket. Tug

down wards on the heater to ensure that both "fingers" of the bracket are seated in the

mounting slots.

FIG. 2/4

FIG. 2/5