- ページ 6

ウォーターヒーター Ariston PRIMO HE ITI 125のPDF 設置、サービス、操作に関する説明書をオンラインで閲覧またはダウンロードできます。Ariston PRIMO HE ITI 125 34 ページ。 Unvented hot water storage cylinders
Ariston PRIMO HE ITI 125 にも：取付・使用説明書 (24 ページ)

ページを印刷する

3.6

Siting and Fixing

A minimum dynamic pressure of 1.5 bar or 20 litres per minute is required

for satisfactory operation. 85% of UK dwellings have a mains pressure

above 2.0 bar.

Note: THE MAINS WATER SUPPLY MUST NOT EXCEED 16 BAR.

The cylinder should be left packed until it is time to install. When unpacking

the appliance follow the guidelines within the packaging and take care not to

damage the temperature and pressure relief valve.

The cylinder may be installed in any convenient position. As it is connected

to the mains cold water supply. Consideration must be given to allow ease

of access for maintenance purposes.

Additionally, do not install the unit in premises which may be subject to

freezing.

Ensure that the floor load bearing strength is adequate to take the weight of

the cylinder when full of water (see Table 1). e.g. Do not install the cylinder

on floors made of chipboard or other flooring where the mechanical strength

is compromised when damp.

The ST50, ST80 and ST100 ProTech models are wall mounted. All other

models are free standing. These are supplied with feet which are attached

to the heater via self-tapping screws which are also supplied.

All units must be installed in the VERTICAL POSITION.

For maintenance purposes leave at least 500 mm free space in front of the

unit, for access.

Important: In the event that the installation of this cylinder wll require a third

sensor to be fitted (i.e. Solar) the following actions will be necessary:

Replace one of the thermostat pockets supplied with the indirect

thermostats in the Unvented Kit with the elongated thermostat pocket also

supplied.

This thermostat and pocket must now be fitted to the top thermostat

connection.

Please also refer to Section 2.3 General Guidance Options A and 8 (page

5) of this manual.

For further technical advice, please contact the Ariston Technical Advice

Line on 0870 241 8180.