- ページ 7

スイッチ Aeotec AEOEZW116のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aeotec AEOEZW116 16 ページ。 Single nano switch with measuring
Aeotec AEOEZW116 にも：クイック・スタート・マニュアル (11 ページ)

ページを印刷する

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existin

devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the

controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a spe

Inclusion

1. Install the device according to the instructions.

2. Press the button 2 times quickly on the Nano Switch.

Exclusion

1. Press the button once on the Dual Nano Switch.

Quick trouble shooting

Here are a few hints for network installation if things dont work as expected.

1. Make sure a device is in factory reset state before including. In doubt exclude before include.

2. If inclusion still fails, check if both devices use the same frequency.

3. Remove all dead devices from associations. Otherwise you will see severe delays.

4. Never use sleeping battery devices without a central controller.

5. Dont poll FLIRS devices.

6. Make sure to have enough mains powered device to beneﬁt from the meshing

Association - one device controls an other device

Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is c

http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW116

30-09-2020 13:25

Pagina 7 van 16