- ページ 2

スイッチ Aeotec NanoMote QuadのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aeotec NanoMote Quad 5 ページ。
Aeotec NanoMote Quad にも：取扱説明書 (10 ページ), ユーザーマニュアル (9 ページ), 取扱説明書 (9 ページ)

ページを印刷する

30-09-2020 13:08

Safety Warning for Batteries

The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of different charging level or different brands.

Installation

Open the cover

Insert your battery and close the cover

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate wi

devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave netwo

controller is turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special manual action right on the device.

Inclusion

1. Open the NanoMote

2. Insert the battery

3. Press the button on the NanoMote One twice

Exclusion

1. Press the button on the NanoMote One twice

Product Usage

LOW BATTERY ALARM FUNCTION

NanoMote Quad will send battery report to the lifeline group when button is triggered during the sleep mode. If the battery level of the NanoMote Quad is le

20%, the NanoMote Quad will send a low battery alarm to the main controller.

CHILD LOCK FUNCTION

Child Lock function. If enable the Child Lock function, the LED indicator will not be on when press down the button. To switch on/off the Child Lock function,

press and hold the button for 10 seconds, the LED indicator will be solid on in red. Then release the button, the LED indicator will be continuously stay in re

seconds. During this 2 seconds, please click the button once, the LED light will be blink fast in red for 2 seconds.

TESTING Z-WAVE NETWORK RANGE

Press and hold the button for 15 seconds, the LED light will be solid on in purple. Then release the button, the LED light will be stay in purple for 2 seconds,

2 seconds, please click the button once, it will start to test the Z-Wave network range and LED light will blink fast in purple. After ﬁnish the test, if the LED li

green, it refers to strong signal; if in blue, it refers to medium signal, and if in red, it refers to weak signal or no signal.

Tip: This function works only when NanoMote Quad has been included into a ZWave network.

http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZWA003

Pagina 2 van 5