スイッチ Aeotec Smart Switch 6のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aeotec Smart Switch 6 7 ページ。
Aeotec Smart Switch 6 にも：ユーザーマニュアル (12 ページ)

ページを印刷する

Aeotec

Smart Switch 6

SKU: AEOEZW096-EU

Quickstart

This is a secure On/Off Power Switch for Europe. To run this device please connect it to your mains power supply. Turn the primary controller of

Z-Wave network into inclusion mode, short press the product's Action button that you can find on the product"s housing.

What is Z-Wave?

Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart

section.

Z-Wave ensures a reliable communication by reconfirming every message ( two-way communication)

and every mains powered node can act as a repeater for other nodes (meshed network) in case the

receiver is not in direct wireless range of the transmitter.

This device and every other certified Z-Wave device can be used together with any other certified Z-

Wave device regardless of brand and origin as long as both are suited for the same frequency

range.

If a device supports secure communication it will communicate with other devices secure as long as

this device provides the same or a higher level of security. Otherwise it will automatically turn into a

lower level of security to maintain backward compatibility.

For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.

Product Description

Aeotec Smart Switch 6 is a low-cost Z-Wave Switch plug-in module specifically used to enable Z-Wave command and control (on/off) of any plug-in tool. It

can report immediate wattage consumption or kWh energy usage over a period of time. In the event of power failure, non-volatile memory retains all

programmed information relating to the unit's operating status.

Its surface has a Smart RGB LED, which can be used for indicating the output load status or strength of the wireless signal. You can configure its indication

colour according to your favour.

The Smart Switch 6 is also a security Z-wave device and supports Over The Air (OTA) feature for the products firmware upgrade.

Prepare for Installation / Reset

Please read the user manual before installing the product.

In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You

can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is

recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.

Reset to factory default

This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is

inoperable.

Press and hold the Action button that you can find on the product"s housing for 20 seconds and then release.

Safety Warning for Mains Powered Devices

ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to

the assembly of the product, the voltage network has to be switched off and ensured against re-switching.

Inclusion/Exclusion

On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate

with the devices of this network. This process is called Inclusion.

Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave