- ページ 8

ボイラー Ariston EURO COMBI 47-116-10のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Ariston EURO COMBI 47-116-10 28 ページ。 Type c boilers

ページを印刷する

2.5

Mounting the Appliance

2.6

Electrical Connection

2.7

Gas Connection

Fasten the boiler in place using the template and anchors supplied with the

unit. It is highly recommended that a spirit level be used to position the boiler so

that it is perfectly level.

For additional information, please consult the instructions contained in the

connection kit and the flue kit.

For safety purposes, have a competent person carefully check the electrical

system in the property, as the manufacturer will not be held liable for damage

caused by the failure to earth the appliance properly or by anomalies in the

supply of power. Make sure that the residential electrical system is adequate for

the maximum power absorbed by the unit, which is indicated on the rating plate.

In addition, check that the section of cabling is appropriate for the power

absorbed by the boiler.

The boiler operates with alternating current, as indicated in the technical data

table (1.2), where the maximum absorbed power is also indicated. Make sure

that the connections for the neutral and live wires correspond to the indications

in the diagram. The appliance electrical connections are situated on the reverse

of the control panel (see the servicing manual for further information)

Important!

In the event that the power supply cord must be changed, replace it with one

with the same specifications. Make the connections to the terminal board

located within the control panel, as follows:

- The yellow-green wire should be connected to the terminal marked with the

earth symbol; make sure to re-use the ferrule mounted on the other supply

cord;

- The blue wire should be connected to the terminal marked "N";

- The brown wire should be connected to the terminal marked "L".

Note: The diagrams for the electrical system are indicated in section 2.11.

Warning, this appliance must be earthed.

External wiring to the appliance must be carried out by a qualified technician

and be in accordance with the current I.E.E. Regulations and applicable local

regulations. The EuroCombi range of boilers are supplied for connection to a

230 V

50 Hz supply.

The supply must be fused at 3 A.

The method of connection to the electricity supply must facilitate complete

electrical isolation of the appliance, by the use of a fused double pole isolator

having a contact separation of at least 3 mm in all poles or alternatively, by

means of a 3 A fused three pin plug and unswitched shuttered socket outlet

both complying with BS 1363.

The point of connection to the electricity supply must be readily accessible and

adjacent to the appliance unless the appliance is installed in a bathroom when

this must be sited outside the bathroom.

The local gas region contractor connects the gas meter to the service pipe.

If the gas supply for the boiler serves other appliances ensure that an adequate

supply is available both to the boiler and the other appliances when they are in

use at the same time.

Pipe work must be of an adequate size. Pipes of a smaller size than the boiler

inlet connection should not be used.

Fig. 2.3

B023