ページを印刷する
03/02/2021
ls -la /dev/ttyS*
2. Open your selected third party software.
3. Following your third party software instructions for connecting a Z-Wave USB adapter. Select the COM or virtual port
Z-Pi 7 is associated to.
In most cases, any devices already paired with Z-Pi 7 network will automatically show up in the software's interface.
Z
Below are the pin outs for the Z-Pi 7.
Z
This must be done through the host software which takes control of Z-Pi 7. Please consult the instruction manual
of the host software to add the Z-Pi 7 to a pre- existing Z-Wave network (i.e. "Learn", "Sync", "Add as Secondary
Controller", etc.).
This function can only be performed through a compatible host software.
Z
Z-Pi also can be reset to the factory defaults settings via the host software (host software can be any third party
software such as: Homeseer, Domoticz, Indigo, Axial, etc).
The host software must take control of Z-Pi.
Find the Reset Z-Wave controller option in your third party software.
https://aeotec.freshdesk.com/support/solutions/articles/6000230551-z-pi-7-user-guide-
Z-PI 7 User Guide : Aeotec Help Desk
Z W
6/7