- ページ 7
ホームオートメーション Aeotec NanoMote QuadのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aeotec NanoMote Quad 9 ページ。
Aeotec NanoMote Quad にも： 取扱説明書 (10 ページ), クイック・スタート・マニュアル (5 ページ), 取扱説明書 (9 ページ)
ページを印刷する
Nano Mote Quad User Guide : Aeotec Group
1. Press and hold the NanoMote button (can be any button) or 20 seconds.
LED will change rom:
Orange
Green
Red
Pink
Red
2. Release the button on the second Red LED status. It will remain red or 2 seconds
3. Tap button again while second Red LED is illuminated (you'll have 2 seconds to do so).
Advanced Parameter Configurations.
Not all gateways will allow you to urther con igure your Z-Wave devices, but in the case that your gateway does allow
it, the NanoMote Quad has some available parameter con igurations that will allow you to con igure it urther to your
liking.
Parameter 32 Level of low battery.
Available settings: 10-50 (10% - 50%)
De ault setting: 20 (20%)
Parameter size: 1[byte]
Parameter 42 Setting the duration value of the command switch multilevel.
Available settings: 0-255
De ault setting: 255
Parameter size: 1[byte]
Parameter 43 Enable/disable the buzzer alarm when battery is running low.
0 - Disable.
1 –Enable.
De ault setting: 0
Parameter size: 1[byte]
Further steps for different -Wave Gateways.
Most gateways will have speci ic steps to use NanoMote Quad via group association (direct control), while others will
have di erent steps to use its scene triggers through the gateway directly or more advanced controls. Below are the
known steps required or the listed gateways.
1. Currently none listed at this time. This section will update later in the uture.
I your gateway is not listed here, please contact support to see i there are possible steps that can be used on your
7 z 9
ttps://aeotec.fres desk.com/support/solutions/articles/6000184696-n...
9. 9. 2019, 15:53