- ページ 6

ボイラー Ariston micro GENUS Type CのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Ariston micro GENUS Type C 25 ページ。 Type c boilers
Ariston micro GENUS Type C にも：ユーザーマニュアル (20 ページ)

ページを印刷する

. 2.1

. 2.2

. 2.3

2.3

EGEND

A = Central Heating Flow (3/4")

B = Domestic Hot Water Outlet (1/2")

C = Gas Inlet (3/4")

D = Domestic Cold Water Inlet (1/2")

E = Central Heating Return (3/4")

2.4

In order to allow for access to the interior of the boiler for

maintenance pur poses, the boiler must be installed in

compliance with the minimum clearances indicated in F

QT002A

2.5

Fasten the boiler in place using the template and anchors

supplied with the unit. It is highly recommended that a

spirit level be used to position the boiler so that it is

perfectly level.

For additional information, please consult the instructions

contained in the connection kit and the flue kit.

2.7

For safety purposes, have a competent person carefully

check the electrical system in the proper ty, as the

manufacturer will not be held liable for damage caused by

the failure to earth the appliance properly or by anomalies

in the supply of power. Make sure that the residential

electrical system is adequate for the maximum power

absorbed by the unit, which is indicated on the rating plate.

In addition, check that the section of cabling is appropriate

for the power absorbed by the boiler.

DM004A

The boiler operates with alternating current, as indicated in

the technical information table section in 6, where the

maximum absorbed power is also indicated. Make sure

that the connections for the neutral and live wires

correspond to the indications in the diagram. The

appliance electrical connections are situated on the

reverse of the control panel (see the servicing manual for

further information)

MPORTANT

In the event that the power supply cord must be changed,

replace it with one with the same specifications. Make the

connections to the terminal board located within the

control panel, as follows:

- The yellow-green wire should be connected to the

VR001A

terminal marked with the "

use the ferrule mounted on the other supply cord;- The

blue wire should be connected to the terminal marked "N";

- The brown wire should be connected to the terminal

VERALL

IMENSIONS

LEARANCES

OUNTING THE

PPLIANCE

LECTRICAL

ONNECTION

" symbol; make sure to re-

. 2.2