- ページ 4

ホームオートメーション Aeotec ZWA042のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aeotec ZWA042 11 ページ。 Outdoor smart plug

ページを印刷する

Button & Indicator Function Description

Button Definition

ITEMS

Action (time unit: second)

Tap one time [0.04,1]

Tap two times [0.04, 1]

Press and hold [5,10]

Press and hold [15,20]

Press and hold [22,∞)

LED indicator

Action

Press down Action Button

Tap one time

Solid Yellow Status

[0.04,1]

Secure / Non-secure network: Purple

Tap twotimes

Led keeps ON for 2 seconds and then

OFF.

Press and hold

LED should revert back to LED state if

[1,1]

paired or unpaired.

Press and hold

Solid orange status

[2,5]

Press and hold

Solid cyan status

[5,9]

Press and hold

Solid red led status

[9,15]

red color will blink on and off at a rate

Press and hold

of 200ms for 2 seconds and then should

[15,20]

pulse blue color based on unpair status.

Description

Out of network: Z-Wave network inclusion(ADD) (send out NIF of full functionality )

In network: N/A

In/Out of network: controls/toggles output on/off

Out of network: N/A

In network: Z-Wave network exclusion(REMOVE: Send out NIF) .

Enter RF power level test mode

Reset to factory default setting and then send Device Reset Locally to primary controller.

Note: Please use this procedure only when the network primary controller is missing or otherwise inoperable.

If still do not release the button, nothing will happen. LED should continue to pulse blue for unpaired state.

Release Action Button

Turns on a solid yellow status, If a new node id is assigned to this device, the yellow LED will keep solid until whole network processing is complete (or

entering. If successful, the LED will flash white -> green -> white -> green (at a rate of 250ms per each color change) for 2 seconds. After 2 seconds have

finished, use typical paired status LED indicators for ON/OFF status from parameter #1. Control function: controls/toggles output on/off

If the exclusion is successful, the Led will pulse a blue LED color based on unpair status.

LED should revert back to LED state if paired or unpaired.

cyan led will remain solid upon releasing the button, which indicates the network quality is entering diagnosing, the led will be light up with 1 of 3 colors

for 2 seconds after the diagnosing is complete. (Red = bad, Yellow = ok, Green = Good)

Reset to factory default setting and then send Device Reset Locally to primary controller

Note: Please use this procedure only when the network primary controller is missing or otherwise inoperable.

ZWA042 User Manual