- ページ 5

ボイラー Ariston STI 125 INDIRECTのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Ariston STI 125 INDIRECT 20 ページ。 Type c
Ariston STI 125 INDIRECT にも：取付・使用説明書 (24 ページ), ユーザーマニュアル (16 ページ)

ページを印刷する

2.2

ITING THE

PPLIANCE

132

. 2.1

2.5

OUNTING THE

2.6

LECTRICAL

ONNECTION

Supplied By www.heating spares.co Tel. 0161 620 6677

The appliance may be installed in any room or indoor area, although particular

attention is drawn to the requirements of the current I.E.E. Wiring Regulations, and in

Scotland, the electrical provisions of the Building Regulations applicable in Scotland,

with respect to the installation of the appliance in a room containing a bath or

shower.

Where a room-sealed appliance is installed in a room containing a bath or

shower the appliance and any electrical switch or appliance control, utilising

mains electricity should be situated so that it cannot be touched by a person

using the bath or shower.

The location must permit adequate space for servicing and air circulation around the

appliance as indicated in paragraph 2.4.

The location must permit the provision of an adequate flue and termination.

For unusual locations special procedures may be necessary.

BS 6798-1987 gives detailed guidance on this aspect.

A compartment used to enclose the appliance must be designed specifically for this

purpose. No specific ventilation requirements are needed for the installation within a

cupboard.

This appliance is not suitable for outdoor installation.

The type C appliances (in which the combustion circuit, air vent intake and

combustion chamber are air-tight with respect to the room in which the

appliance is installed) can be installed in any type of room.

Secondary ventilation is not required with this boiler. The boiler must be installed on

a solid, permanent wall to prevent access from the rear.

60 mm

450 mm

Fasten the boiler in place using the template and anchors supplied with the unit. It is

PPLIANCE

highly recommended that a spirit level be used to position the boiler so that it is

perfectly level.

For additional information, please consult the instructions contained in the

connection kit and the flue kit.

For safety purposes, have a competent person carefully check the electrical system

in the property, as the manufacturer will not be held liable for damage caused by the

failure to earth the appliance properly or by anomalies in the supply of power. Make

sure that the residential electrical system is adequate for the maximum power

absorbed by the unit, which is indicated on the rating plate. In addition, check that the

section of cabling is appropriate for the power absorbed by the boiler.

2.3

VERALL

IMENSIONS

EGEND

= Central Heating Flow (3/4")

= Gas Inlet (3/4")

= Central Heating Return (3/4")

mm = Clearances

2.4

LEARANCES

In order to allow for access to the interior of the boiler for

maintenance pur poses, the boiler must be installed in

compliance with the minimum clearances indicated in F

. 2.1