- ページ 12

オーブン Ariston 7 Chefs FO 87 C.2/EのPDF 取付・使用説明書をオンラインで閲覧またはダウンロードできます。Ariston 7 Chefs FO 87 C.2/E 14 ページ。 New oven “7 chefs”
Ariston 7 Chefs FO 87 C.2/E にも：取付・使用説明書 (14 ページ)

ページを印刷する

The appliance must be installed only by a qualified

person in compliance with the instructions provided.

The manufacturer declines all responsibility for improper

installation which may harm persons and animals and

damage property.

Important: The power supply to the appliance must be

cut off before any adjustments or maintenance work is

done on it.

Installation of Built-in Ovens

In order to ensure that the built-in appliance functions prop-

erly, the cabinet containing it must be appropriate. The

figure below gives the dimensions of the cut-out for instal-

lation under the counter or in a wall cabinet unit.

N.B.: Installation in compliance with the consumption declaration

In order to ensure adequate ventilation, the back panel of

the cabinet unit must be removed. Installing the oven so

that it rests on two strips of wood is preferable. If the oven

rests on a continuous, flat surface, there must be an ap-

erture of at least 45 x 560 mm.

Instalation

The panels of the adjacent cabinets must be made of heat-

resistant material. In particular, cabinets with a veneer ex-

terior must be assembled with glues which can withstand

temperatures of up to 100 °C.

In compliance with current safety standards, contact with

the electrical parts of the oven must not be possible once

it has been installed.

All parts which ensure the safe operation of the appliance

must be removable only with the aid of a tool.

For the correct centring of your appliance, position the 4

tabs on the sides of the oven in correspondence with the

4 holes on the perimeter of the frame. In particular, if the

cabinet side panel:

•

is 20 mm thick: the removable part of the tab must be

removed (Fig. A);

is 18 mm thick: use the first groove, which is factory-

•

set (Fig. B);

is 16 mm thick: use the second groove (Fig.C)

•

Fig. A

To fasten the oven to the cabinet, open the door of the

oven and attach it by inserting the 4 wooden screws into

the 4 holes located on the perimeter of the frame.

Electrical Connection

Those ovens equipped with a three-pole power supply

cable are designed to operate with an alternating current

with the voltage and frequency indicated on the data plate

(located on the appliance) and in the instruction manual.

The wire for earthing the appliance is yellow-green in col-

our.

Fig. B

Fig. C