- ページ 4

オーブン Ariston A64IMCA1のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ariston A64IMCA1 20 ページ。 Cooker and oven

ページを印刷する

1. Electrical Connection

-breaker with a minimum opening of 3 mm between the con-

tacts, suitable for the load indicated and complying with cur-

rent directives, must be installed between the appliance and

the mains (the earthing wire must not be interrupted by the

circuit-breaker). The power supply cable must be positioned

so that it does not exceed room temperature by 50°C at any

point of its length. Before making the connection check that:

•

the limiter valve and the home system can support

appliance load (see data plate);

•

the power supply system has an efficient earthing

connection which complies with the provisions of current regu-

lations and the law;

•

there is easy access to the socket or the omnipolar

circuit-breaker once the cooker has been installed.

! Do not use reducers, adapters or shunts as these could cau-

se heating or burning.

Connecting the supply cable to the electricity mains

Install a standardised plug corresponding to the load

indicated on the appliance data plate (see Technical data

table).

The appliance must be directly connected to the mains using

an omnipolar switch with a minimum contact opening of 3

mm installed between the appliance and the mains. The

switch must be suitable for the charge indicated and must

comply with current electrical regulations (the earthing wire

must not be interrupted by the switch). The supply cable

must be positioned so that it does not come into contact with

temperatures higher than 50°C at any point.

Before connecting the appliance to the power supply, make

sure that:

• The appliance is earthed and the plug is compliant with the law.

• The socket can withstand the maximum power of the

appliance, which is indicated by the data plate.

• The voltage falls between the values indicated on the data

plate.

• The socket is compatible with the plug of the appliance. If

the socket is incompatible with the plug, ask an authorised

technician to replace it. Do not use extension cords or

multiple sockets.

! Once the appliance has been installed, the power supply

cable and the electrical socket must be easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by

authorised technicians only.

! The manufacturer declines any liability should these

safety measures not be observed.

means of a screw (not supplied with the cooker) to the wall

behind the appliance, at the same height as the chain is atta-

ched to the appliance.

Choose the screw and the screw anchor according to the type

of material of the wall behind the appliance. If the head of the

screw has a diameter smaller than 9mm, a washer should

be used. Concrete wall requires the screw of at least 8mm of

diameter, and 60mm of length.

Ensure that the chain is ﬁ xed to the rear wall of the coo-

ker and to the wall, as shown in ﬁ gure, so that after instal-

lation it is tensioned and parallel to the ground level.

TABLE OF CHARACTERISTICS

Oven dimensions

(HxWxD)

Volume

Useful

measur ement s

relating to the

oven

compartm ent

Voltage and

frequenc y

ENERGY LABEL

Safety Chain

! In order to prevent ac-

cidental tipping of the

appliance, for example by

a child climbing onto the

oven door, the supplied

safety chain MUST be

installed!

The cooker is ﬁ tted with a

safety chain to be ﬁ xed by

Eco