- ページ 4

セキュリティセンサー Aeotec MULTISENSOR 6のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aeotec MULTISENSOR 6 8 ページ。 Z-wave water and flood sensor
Aeotec MULTISENSOR 6 にも: ユーザーマニュアル (13 ページ), マニュアル (3 ページ), マニュアル (10 ページ), ユーザーマニュアル (13 ページ)

Aeotec MULTISENSOR 6 ユーザーマニュアル
11/21/2017
3. Water is detected by sensing point 1 and 2.
4. Water is detected by sensing point 3 and 4.
5. Water is detected by sensing point 1, 2, 3 and 4.
These situations will cause Water Sensor 6 to send a water presence or trigger event to your gateway. Should water clear
from the area where Water Sensor 6 is installed, the sensor will also send a separate command to your Z-Wave gateway
informing it that there is no more water in the area.
Installing Dock for Water Sensor 6.
You can choose to install Water Sensor 6 on Dock for Water Sensor 6 for permanent power via USB and installation of
probes to extend the detection to different locations. You can follow the Dock for Water Sensor 6 user guide
(https://aeotec.freshdesk.com/solution/articles/6000176812-dock-for-water-sensor-6-user-guide-)
installation steps.
Additional information on other Gateways uses.
Smartthings Hub.
Smartthings hub has basic compatibility to the Water Sensor 6, it does not allow you to access its advanced configuration
functions readily. In order to make full use of your Water Sensor 6 to its fullest, you must install a custom device handler in
order to access other functions of the switch.
You can find the article for the custom device handler here: https://aeotec.freshdesk.com/solution/articles/6000184942-
water-sensor-6-smartthings-hub-device-handler-
sensor-6-smartthings-hub-device-handler-)
https://aeotec.freshdesk.com/support/solutions/articles/6000171886-water-sensor-6-user-guide-
Water Sensor 6 user guide. : Aeotec by Aeon Labs
(https://aeotec.freshdesk.com/solution/articles/6000184942-water-
to follow up with the
4/8