- ページ 4

オーブン Ariston DN62X AUSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Ariston DN62X AUS 28 ページ。 Built-in multifunction double oven

ページを印刷する

Installation

Ensure that the electricity supply is turned off

before installing your appliance.

IMPORTANT

DO NOT LIFT OVEN BY THE DOOR HANDLES.

This equipment is designed specifically for

domestic purposes and Hotpoint Limited cannot

accept responsibility if used for any other type of

application.

All electrical installations must be carried out by

a NICEIC registered installer.

WARNING: THIS APPLIANCE MUST BE EARTHED.

1. General

The appliance is designed for mounting at a safe

level into an open housing which must be

secured to the backing wall.

2. Oven Unit Housing Cabinets

• The oven unit housing cabinet dimensions

must comply with Fig. 4.

• An air gap of 50 mm minimum must be

provided at the rear of any top or bottom

cupboards or shelves. (See Fig. 1).

• Ventilation must be unobstructed, ie. From

adjacent cabinetry. This can be done by

either raising the base of the cabinets using

the adjusting feet (or spacers) or alternatively

by providing a slot in the cabinet plinth to the

dimensions shown overleaf.

• The air gap at the rear allows the warmed air

to pass out of the inner cabinet space, but

where it is intended to fit cupboards above

the oven unit to ceiling height it is essential

that the warmed air is exhausted through the

front of the cabinet Fig. 1.

• If an oven unit is installed adjacent to a tall

cabinet, steam escaping from the oven when

the door is opened could condense on, and

perhaps stain, the adjacent surface. To

prevent permanent staining, the adjacent

surface should be made of a material that is

heat resistant and easy to clean. Adjacent tall

cabinets should not be deeper than the oven

housing cabinet.

IMPORTANT

It is essential that the lower cupboard is constructed

in the manner illustrated. having side, back and roof

panels so joined as to provide no apertures which

could permit access to the oven unit when installed.

3. Final Installation

• Using a spirit level, check that the housing

cabinet is level from side to side and from

front to back in its installed position.

• Correct any unevenness by placing wooden

packing under the bottom of the cabinet.

Make sure that the cabinet rests firmly on the

cabinet floor without rocking.

• Before the oven is fitted, the cabinet must be

firmly secured to the backing wall for stability.

• The oven unit should now be lifted (by 2

adults) into the cabinet and pushed fully

home.

• Finally the oven unit must be secured to the

cabinet by means of the four pozi wash head

screws, two through each side trim.

• REMOVE ALL PACKING MATERIAL FROM

THE GRILL AND OVEN INTERIOR.

List of Loose Items

4 x Pozi Wash Head No. 6 x 15mm screws.

Fitting the guide rails

For the sake of re-fitting the guide-rails of the oven

e.g. after cleaning, begin with the lower holes on the

right side and the upper holes on the left side. Insert

the two pins "H" into the holes provided and fit the

support "A" between the two plugs "G"

G G G G G

A A A A A

H H H H H