- ページ 5

セキュリティシステム Aeotec Siren 6のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Aeotec Siren 6 7 ページ。 Indoor siren
Aeotec Siren 6 にも：ユーザーマニュアル (6 ページ), クイック・スタート・マニュアル (10 ページ)

ページを印刷する

With your Siren now working as a part of your smart home, you'll be able to configure it from your

home control software. Please refer to your software's user guide for precise instructions on

configuring Siren to your needs.

Advanced.

Removing your Siren from a Z-Wave network.

Your Siren can be removed from your Z-Wave network at any time. It is always advised that you use

your gateway to perform an unpair in order to avoid leaving phantom / failed nodes that become

difficult to remove. To do so, follow the steps below:

1. Place your gateway or controller into Z-Wave unpair or exclusion mode. (Please refer to your

controller/gateway manual on how to do this)

2. Press the Action Button 6x times in 2 seconds on your Siren.

3. If your Siren has been successfully unpaired from your network, its LED will begin to blink slowly

which indicates that it is ready to be paired again.

Test Siren 6 sound manually.

You will be able to manually test your Siren 6 unpaired or paired to a Z-Wave network, to determine if

its sound is working, perform the button action listed below:

•

Press and hold Action Button down for 2-5 seconds

Safety: Test only when wearing necessary ear protection. Siren 6's speaker emits tones up to

105dB that can cause hearing damage.

Reset your Siren.

This method is not fully advised unless your gateway has failed, and you do not yet have another

gateway to perform a general unpair on Siren 6.

To do this, follow the steps below:

1. Press and hold the Action button for 20 seconds

2. [2-5 seconds], the test siren sound will run, then stop after 5 seconds has passed.

3. [5-20 seconds] The LED will continue to blink faster (5 to 10 seconds) and faster (10 to 20

seconds).

4. [21 seconds and later] The LED will then quickly flash 3 times then will have LED breath in

and out as you hold down the Action Button

5. Release the Action button, and the Siren 6 will factory reset.