- ページ 2
ホブ Ariston PH 741 RQO GH AUSのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ariston PH 741 RQO GH AUS 11 ページ。 Ariston hob
Ariston PH 741 RQO GH AUS にも: 取扱説明書 (12 ページ), 仕様 (13 ページ), 取扱説明書 (24 ページ), 取扱説明書 (24 ページ), 取扱説明書 (12 ページ)
![Ariston PH 741 RQO GH AUS ユーザーマニュアル](/uploads/products/server2/679149/679149.jpg)
The position of the corresponding gas burner or electric
hot plate (if present) is indicated on each control knob.
Gas Burners
The burners differ in size and power. Choose the most
appropriate one for the diameter of the cookware being
used.
The burner can be regulated with the corresonding control
knob by using one of the following settings:
•
Off
High
Low
To light the selected burner, first press the
corresponding knob down fully, turn it anti-clockwise
to the high flame symbol, and keep the knob pressed
down until the burner ignites for approximately 2-3
seconds to allow the safety device "F", which keeps the
flame lit automatically, to heat up.
To turn on one of the burners, place a lighted match or
lighter near the burner, press the knob all the way in and
turn it anti-clockwise to the "High" setting.
To turn off a burner, turn the knob clockwise until it stops
(it should be on the "•" setting).
Caution: If the burner accidently goes out, turn off the
gas on the control knob and wait at least 1 minute before
you try to to light it again.
The "separate double flame" burner
This burner consists of two concentric burners which can
operate either together or separately.
Use of the double flame on the maximum setting gives a
very high power which reduces cooking times with respect
to conventional burners.
Moreover the double flame crown provides a more uniform
distribution of heat on the bottom of the pan, when using
both burners on minimum.
Pots and pans of all sizes can be used. In the case of the
smaller pots and pans we recommend the use of only the
internal burner.
There is a separate control knob for each of the "separate
double flame" burners.
The knob marked by the symbol
burner;
The knob marked by the symbol
burner.
To turn on one of the rings, press the relative knob in all the
way and turn it anti-clockwise to the high setting
is fitted with an electronic igniter that automatically starts when
the knob is pressed in.
How To Use Your Appliance
operates the external
operates the internal
. The burner
13
Since the burner is equipped with a safety device "F",
after lighting the burner keep the knob pressed in for
about 2-3 seconds to allow the device which keeps the
flame lit automatically to heat up.
The selected burner can be regulated using the corresponding
knob, as follows:
•
Off
High
Low
To turn off a burner, turn the knob clockwise until it stops
(it should be on the "•" setting).
Ceramic Glass Module (only on certain models)
This cooktop is fitted with dual-ring radiant heating elements
located beneath the glass. It is possible to turn on only the
circular part of the elemement (identified by the letter "A") or
the cooking surface can be enlarged by turning on both "A"
and "B". To turn only the circular "A" element, simply turn the
knob in the clockwise direction to any one of the 12 available
settings. To add the "B" section, turn the knob to setting 12
and then click it into the
the knob in the counter-clockwise direction to one of the 12
settings.
The figure shows the heating zones, which become red when
the element is turned on.
A. Circular heating zone;
B. Extended heating zone;
C. Indicator light to show when the cooking zone is above
60°C, even after the heating element has been turned
off.
When the knob is on any of the settings other than "Off",
the "H" operating light comes on.
setting. Then proceed by turning
A