- ページ 15

洗濯機 Whirlpool WFW9351YWのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool WFW9351YW 48 ページ。 Clothes washer
Whirlpool WFW9351YW にも：エネルギー・マニュアル (2 ページ)

ページを印刷する

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.whirlpool.com/help

If you experience

Error Code Appears in Display

Once any possible issues are corrected, press START/PAUSE once to clear the code.

Then press START/PAUSE again to restart washer. If code appears again, call for service.

Sd (Excess suds)

Excessive suds in washer. Washer is

appears in display

running a suds reduction routine.

F8E1 (long fill – no

Check for proper water supply.

water supply error)

appears in display

Check plumbing for correct drain hose

F9E1 (drain pump

installation. Drain hose extends into

system error) appears

standpipe farther than 4.5" (114 mm).

in display

F--E-- code (Washer

System error code.

problem)

Vibration or Off-Balance

Vibration, rocking, or

Feet may not be in contact with the

"walking"

floor and locked.

Washer may not be level.

Load could be unbalanced

or too large.

The shipping bolts are still in the

back of the washer.

for assistance and to possibly avoid a service call.

Possible Causes

Allow the machine to continue. Use only HE detergent.

Always measure detergent, and base detergent quantity on

load size. Follow detergent manufacturer's instructions. If the

dial is flashing, reselect your desired cycle using a cold wash

temperature, and press START/PAUSE. Do not add detergent.

Make sure hot and cold inlet hoses are not reversed.

Both hoses must be attached and have water flowing to the

inlet valve.

Both hot and cold water faucets must be on.

Inlet valve screens on washer may be clogged.

Remove any kinks in the inlet hose.

Press START/PAUSE once to clear the code. Then press

START/PAUSE again to restart washer. If code appears again,

call for service.

Check drain hose for proper installation.

Make sure the drain hose is not kinked, pinched, or blocked.

Remove any clogs from drain hose.

Use drain hose form and securely attach to drainpipe or tub.

Lower drain hose if the end is higher than 96" (2.4 m) above

the floor.

Press POWER to cancel cycle and clear the code. Then press

POWER and select RINSE/DRAIN & SPIN if there is excessive

water in the washer. If the code appears again, call for service.

Front and rear feet must be in firm contact with floor, and washer

must be level to operate properly. Jam nuts must be tight

against the bottom of the cabinet.

Check floor for flexing or sagging. If flooring is uneven, a 3/4"

(19 mm) piece of plywood under your washer will reduce sound.

See "Level Washer" in "Installation Instructions."

Avoid tightly packing the load. Avoid washing single items.

Balance a single item such as a rug or jacket with a few extra

items.

Use Heavy Duty or Bulky Items cycle for oversized,

non-absorbent items such as comforters or poly-filled

jackets. Other items are not appropriate for Heavy Duty

or Bulky Items cycle. See "Cycle Guide."

Item or load not suitable for selected cycle. See "Cycle Guide"

and "Using Your Washer" in this "Use and Care Guide."

See "Remove Transport System," in "Installation Instructions."

Solution