- ページ 23
洗濯機 Whirlpool 3360461のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3360461 28 ページ。 Two speed washers
Caring
for your
washer
To keep your washer looking like new:
l
Wipe up detergent,
bleach or other spills with
a soft, damp cloth as they occur.
l
Sharp or heavy objects should not be put on
or in the washer.
Check pockets for bolts,
nuts, etc.
9 If the washer interior needs cleaning,
put 1
cup (250 mL) of chlorine bleach and 2 cups
(500 mL) of detergent
in the washer.
Run
through a complete
cycle using hot water.
l
When removing
hard water deposits,
use
only cleaners
labeled as being washer safe.
l
After tinting or dyeing, put chlorine bleach
and detergent
in the washer.
Run through a
complete
cycle using hot water to remove
excess dye or tint. If staining occurs on
following
loads, repeat the process.
Saving
energy
l
Use hot water only when washing
heavy,
greasy soils or whites.
. Use cold rinses.
l
Wash full loads.
l
Use lower water levels when washing
small
loads.
l
Avoid rewashing.
Use enough detergent;
pretreat stains or heavy soils; do not over-
load; use the cycles and wash times recom-
mended for the fabric and soil; sort properly.
l
Use your washer during off-peak
hours-
usually early morning and late evening.
(Ask
your power company.)
Winterizing
your
washer
Install and store your washer where it will not
freeze. Because
some water stays in the
washer, freezing
can damage
it. If your washer
is stored or moved during freezing
weather,
winterize
it.
1. Shut off both water faucets. Disconnect
the
drain water inlet hoses.
2. Put 1 quart (1 L) of R.V.-type
antifreeze
in
the basket.
To use the washer
again
. . .
1. Flush water pipes and hoses.
2. Reconnect
water inlet hoses.
3. Turn on both water faucets.
4. Run the washer through a complete
cycle
with 1 cup (250 mL) of detergent
to clean
out antifreeze.
3. Run washer on a drain and spin setting for
about 30 seconds
(see page 9) to mix
antifreeze
and water.
23