- ページ 7

洗濯機 Whirlpool 3XLBR8543のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3XLBR8543 35 ページ。 Two speed automatic washer
Whirlpool 3XLBR8543 にも：取扱説明書 (13 ページ), 取付説明書 (11 ページ), 取扱説明書 (40 ページ)

ページを印刷する

6. Set the TEMPERATURE selector to the correct setting for the

type of fabric and soils being washed. Use the warmest water

safe for fabric. Follow garment label instructions.

Your washer uses automatic temperature control (on some

models) to maintain a uniform water temperature by

regulating the incoming hot and cold water. This helps

eliminate undissolved detergent and ensures consistent

cleaning results. The cold wash is regulated at approximately

75°F (24°C) by adding small amounts of hot water during the

cold fill. The warm wash is maintained at approximately

100°F (38°C).

NOTE: Make sure that both the hot and cold water taps are

fully turned on or the automatic temperature control feature

will not work properly.

Water Temp

Use For

Hot

Whites and pastels

111°F (44°C)

Heavy and greasy soils

or above

Warm

Bright colors

90°-110°F

Moderate to light soils

(32°-43°C)

Cold

Colors that bleed or fade

70°-90°F

Light soils

(21°-32°C)

NOTE: In wash water temperatures colder than 70ºF

(21ºC), detergents do not dissolve well. Soils can be difficult

to remove. Some fabrics can retain wear wrinkles and have

increased pilling (the formation of small lint-like balls on the

surface of garments).

7. (OPTIONAL) Some models have an EXTRA RINSE selector.

For an additional rinse and spin at the end of a wash cycle,

set the EXTRA RINSE selector to ON. On some models, the

Extra Rinse feature is part of the cycle.

8. (OPTIONAL ) Some models have an END OF CYCLE SIGNAL

selector. Set the END OF CYCLE SIGNAL selector to ON if

you want your washer to alert you when the wash cycle is

complete. The signal is helpful when you are washing items

that should be removed from the washer as soon as the cycle

ends.

9. Push in the Cycle Control knob and turn it clockwise to the

wash cycle you want. Reduce the wash time when using a

small load size setting. See "Selecting a Cycle and Time."

Pull out the Cycle Control knob to start the washer.

To stop or restart your washer

To stop the washer at any time, push in the Cycle Control

knob.

To restart the washer, close the lid (if open) and pull out

the Cycle Control knob.

Adding bleach to models without a bleach dispenser

If desired, add measured liquid chlorine bleach after the washer

starts agitating. Pour diluted bleach around the agitator, not

directly on the load. Undiluted bleach will damage any fabric it

touches. (See "Adding Liquid Chlorine Bleach.")

Adding softener to models without a fabric softener

dispenser

If desired, add measured liquid fabric softener to the final rinse

water. Always dilute fabric softener with

250 mL) cup of warm water. Undiluted fabric softener can stain

fabrics. (See "Adding Liquid Fabric Softener.")

Washer Symbols

The control panel of your washer contains symbols. Refer to the

chart below for a definition of those symbols.

Symbols

Small Load

Large Load

Cold

Temperature

Warm

Temperature

Hot

Temperature

Off

Buzzer

Cotton

Synthetics

Delicates

to 1 cup (125 to

Symbols

Hand Washables

Super Wash

Wash

Quick Wash

Prewash

Rinse

Extra Rinse

Spin

Slow Spin

Cool Down

Pull Start

Push Stop