- ページ 8

洗濯機 Whirlpool 3XWTW5105のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 3XWTW5105 36 ページ。 Two speed automatic washers
Whirlpool 3XWTW5105 にも：取扱説明書 (36 ページ)

ページを印刷する

6. Set the TEMPERATURE selector to the correct setting for the

type of fabric and soils being washed. Use the warmest water

safe for fabric. Follow garment label instructions.

Your washer uses automatic temperature control (on some

models) to maintain a uniform water temperature by regulating

the incoming hot and cold water. This helps eliminate

undissolved detergent and ensures consistent cleaning

results. The Hot and Warm settings on this washer will be

cooler than you are accustomed to. Wash temperatures in this

washer are lower than the temperatures you may be used to in

conventional washers.

NOTE: Make sure that both the hot and cold water taps are

fully turned on, or the automatic temperature control feature

will not work properly.

Water Temp

Use For

Hot

Whites and pastels

Heavy soils

Warm

Bright colors

Moderate to light soils

Cold

Colors that bleed or fade

Light soils

NOTE: In wash water temperatures colder than 15.6ºC,

detergents do not dissolve well. Soils can be difficult to

remove. Some fabrics can retain wear wrinkles and have

increased pilling (the formation of small lint-like balls on the

surface of garments).

7. (OPTIONAL) Some models have an EXTRA RINSE selector.

For an additional rinse and spin at the end of a wash cycle,

set the EXTRA RINSE selector to ON. On some models, the

Extra Rinse feature is part of the cycle.

8. (OPTIONAL) Some models have an END OF CYCLE SIGNAL

selector. Set the END OF CYCLE SIGNAL selector to ON if you

want your washer to alert you when the wash cycle is complete.

The signal is helpful when you are washing items that should be

removed from the washer as soon as the cycle ends.

9. Push in the Cycle Control knob and turn it clockwise to the

wash cycle you want. Reduce the wash time when using a

small load size setting. See "Selecting a Cycle and Time."

Pull out the Cycle Control knob to start the washer.

To stop or restart your washer

To stop the washer at any time, push in the Cycle Control

knob.

To restart the washer, close the lid (if open) and pull out

the Cycle Control knob.

Adding bleach to models without a bleach dispenser

If desired, add measured liquid chlorine bleach after the washer

starts agitating. Pour diluted bleach around the agitator, not

directly onto the load. Undiluted bleach will damage any fabric it

touches. See "Adding Liquid Chlorine Bleach."

Adding softener to models without a fabric softener

dispenser

If desired, add measured liquid fabric softener to the final rinse

water. Always dilute fabric softener with 125 to 250 mL of warm

water. Undiluted fabric softener can stain fabrics. See "Adding

Liquid Fabric Softener."

Washer Symbols

The control panel of your washer contains symbols. Refer to the

chart below for a definition of those symbols.

Symbols

Small Load

Large Load

Cold

Temperature

Warm

Temperature

Hot

Temperature

Off

Buzzer

Cotton

Synthetics

Delicates

Symbols

Hand Washables

Super Wash

Wash

Quick Wash

Prewash

Rinse

Extra Rinse

Spin

Slow Spin

Cool Down

Pull Start

Push Stop