- ページ 11
洗濯機 Whirlpool 49のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 49 14 ページ。 5kg, 1000rpm fully integrated washing machine awo/d 049
![Whirlpool 49 取扱説明書](/uploads/products/server2/6792033/6792033.png)
30110447GB.fm Page 11 Thursday, May 10, 2007 12:35 PM
Description of red indications
Red indication lights up
"Water tap closed"
"Clean pump"
Black process 45.0° 100.0 LPI
Possible causes
Appliance has no or insufficient water supply. The "Start/Pause" light
flashes.
Check whether:
• Water tap is fully open and water supply pressure is sufficient.
• Kinks are present in the water inlet hose.
• Mesh filter of water supply hose is blocked (see "Care And
Maintenance".
• The water hose is frozen up.
• The safety valve inspection window of your water supply hose is red
(provided your appliance has a water supply hose as shown on picture
"B" - see previous chapter "Care And Maintenance"); replace the hose
by a new one available through our After-Sales Service or your specialist
dealer.
After problem has been removed, restart programme by pressing "Start/
Pause". If the fault occurs again, contact our After-Sales Service (see next
chapter).
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
• Kinks are present in the drain hose.
• Filter or pump is blocked (see chapter "Removing The Filter"; make
sure the water has cooled before draining the appliance).
• The drain hose is frozen up.
After problem has been removed, select and start the "Drain" programme
or push the "Reset" button for at least 3 seconds; afterwards restart the
desired programme. If the fault occurs again, contact our After-Sales-
Service (see next chapter).
GB 11
Description
Solutions