- ページ 7

洗濯機 Whirlpool 4GMVWCl00のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 4GMVWCl00 27 ページ。
Whirlpool 4GMVWCl00 にも：取付説明書 (27 ページ)

Attach the brass female end of the "Y"

connector to the cold water faucet. Use pliers

to tighten couplings an additional two-thirds turn. One end of

the long hose has a wire mesh strainer inside the coupling.

Attach this end to the "Y" connector. Attach washer cold inlet

hose to other side of "Y" connector. Screw on coupling by

hand until it is seated on connector. Using pliers, tighten the

couplings an additional two-thirds turn.

IMPORTANT:

Do not overtighten

or use tape or sealants

on valve when attaching to faucets or washer. Damage

can result.

Clear water

lines

Run water for a few seconds through hoses into a laundry tub,

drainpipe, or bucket to avoid clogs. Water should run until clear.

Make note of which hose is connected to hot water to help in

attaching hoses to washer correctly.

flO.

Connect

inlet hoses to washer

#0@_'

¢@Li#

Attach hot water hose to hot water inlet valve marked with a

red ring. Screw coupling by hand until it is snug. Use pliers to

tighten couplings an additional two-thirds

turn. Repeat with

cold water inlet valve.

IMPORTANT: To reduce risk of hose failure, replace the hoses

every 5 years. Record hose installation or replacement

dates

for future reference.

[] Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

11.

Check

for leaks

Turn on water faucets to check for leaks. A small amount of

water may enter washer. It will drain later.

Standpipe

Secure drain hose to laundry tub leg, drain standpipe, or inlet

hoses for wall standpipe with cable tie.