- ページ 12

洗濯機 Whirlpool 4GNTW4400のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 4GNTW4400 44 ページ。 Top-loading washer
Whirlpool 4GNTW4400 にも：取付説明書 (27 ページ), 取付説明書 (27 ページ), 取付説明書 (27 ページ)

ページを印刷する

TROUBLESHOOTING

Electrical Shock Hazard

Plug into a grounded (earthed)

outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or e|ectrical shock.

if you experience

Washer won't run

or fill, washer stops

working or wash light

remains on (indicating

that the washer was

unable to fill

appropriately)

(cont.)

Washer not draining/

spinning, loads

are still wet, or spin

light remains on

(indicating that the

washer was unable

to pump out water

within 10 minutes)

First try the solutions suggested here to possibly avoid the cost of a service call.

Possible Causes

Check proper electrical supply.

Normal washer operation.

Washer may be tightly packed.

Empty pockets and use garment bags

for small items.

Use a cycle with a low spin speed.

The washer may be tightly packed or

unbalanced.

Solution

Plug power cord into a grounded outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician.

Lid must be closed for washer to run.

Washer will pause during certain phases of cycle. Do not

interrupt cycle.

Remove several items, rearrange load evenly in basket, and add

detergent. Close lid and press START/Pause/Unlock

Lid.

Do not add more than 1 or 2 additional items after cycle has

started to avoid tightly packing or unbalancing.

Small items may have been caught in pump or between basket

and tub, which can slow draining.

Cycles with lower spin speeds remove less water than cycles

with high spin speeds. Use the recommended

cycle/speed

spin

for your garment. To remove extra water in the load, select Drain/

Spin. Load may need to be rearranged to allow even

distribution

of the load in the basket.

Tightly packed or unbalanced

loads may not allow the washer

to spin correctly, leaving the load wetter than normal. Evenly

arrange the wet load for balanced spinning. Select the Drain/Spin

cycle to remove excess water. See "Using Your Washer"

for loading recommendations.

Check plumbing for correct drain hose

installation. Drain hose extends into

standpipe farther than 114 mm (4.5").

Too much detergent causing suds to

slow or stop draining and spinning.

Check drain hose for proper installation. Use drain hose form

and securely attach to drainpipe or tub. Do not tape over drain

opening. Lower drain hose if the end is higher than 1.25 m (4')

above the floor. Remove any clogs from drain hose.

Always measure and follow detergent directions for your

load. To remove extra suds, select Rinse & Spin. Do not

add detergent.