- ページ 11

洗濯機 Whirlpool 4KWTW4605FW0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 4KWTW4605FW0 16 ページ。 Top-loading washer
Whirlpool 4KWTW4605FW0 にも：取付説明書 (11 ページ)

ページを印刷する

IMPORTANT:

To prevent damage to washer and personal injury, any

transport/installation of washer requires two-person handling.

WINTER STORAGE CARE

IMPORTANT: To avoid damage, install and store washer

where it will not freeze. Because some water may stay in

hoses, freezing can damage washer. If storing or moving

during freezing weather, winterize your washer.

To winterize washer:

1. Shut off both water faucets; disconnect and drain water

inlet hoses.

2. Put 1 L (1 qt.) of R.V.-type antifreeze in basket and run

washer on Rinse & Spin cycle for about 30 seconds

to mix antifreeze and remaining water.

3. Unplug washer or disconnect power.

TRANSPORTING YOUR WASHER

1. Shut off both water faucets. Disconnect and drain water

inlet hoses.

2. If washer will be moved during freezing weather, follow

"Winter Storage Care" directions before moving.

3. Disconnect drain from drain system and drain any

remaining water into a pan or bucket. Disconnect

drain hose from back of washer.

4. Unplug power cord.

5. Place inlet hoses and drain hose inside washer basket.

6. Drape power cord over edge and into washer basket.

7. Place packing tray from original shipping materials back

inside washer. If you do not have packing tray, place heavy

blankets or towels into basket opening. Close lid and place

tape over lid and down front of washer. Keep lid taped until

washer is placed in new location.

IMPORTANT: Washer must be transported in the upright

position and secured with shipping straps to avoid tipping.

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,

or moving:

1. Refer to "Installation Instructions" to locate, level, and

connect washer.

2. Before using again, run washer through the following

recommended procedure:

To use washer again:

1. Flush water pipes and hoses. Reconnect water inlet hoses.

Turn on both water faucets.

2. Plug in washer or reconnect power.

3. Run washer through Clean Washer cycle (or Bulky Items

cycle at a hot temperature for those models without Clean

Washer cycle) to clean washer and remove antifreeze, if

used. Use half the manufacturer's recommended amount

of detergent for a medium-size load.