- ページ 13

洗濯機 Whirlpool 4KWTW5700JWのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 4KWTW5700JW 40 ページ。 Top-loading high efficiency washer

ページを印刷する

WARNING

Excessive Weight Hazard

Use two or more people to move and install

washer.

Failure to do so can result in back or other injury.

NON-USE AND VACATION CARE

Operate your washer only when you are home. If moving,

or not using your washer for a period of time, follow these

steps:

1. Unplug or disconnect power to washer.

2. Turn off water supply to washer, to avoid flooding due

to water-pressure surge.

WINTER STORAGE CARE

IMPORTANT: To avoid damage, install and store washer

where it will not freeze. Some water may stay in hoses, and

freezing can damage washer. If storing or moving during

freezing weather, winterize your washer.

To winterize washer:

1. Shut off both water faucets; disconnect and drain

water inlet hoses.

2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run

washer on Rinse & Spin cycle for about 30 seconds to

mix antifreeze and remaining water.

3. Unplug washer or disconnect power.

TRANSPORTING YOUR WASHER

1. Shut off both water faucets. Disconnect and drain

water inlet hoses.

2. If washer will be moved during freezing weather, follow

"Winter Storage Care" directions before moving.

3. Disconnect drain hose from drain system and drain any

remaining water into a pan or bucket. Disconnect drain

hose from back of washer.

4. Unplug power cord.

5. Place inlet hoses and drain hose inside washer basket.

6. Drape power cord over edge and into washer basket.

7. Place packing tray from original shipping materials back

inside washer. If you do not have packing tray, place

heavy blankets or towels into basket opening. Close

lid and place tape over lid and down front of washer.

Keep lid taped until washer is placed in new location.

Transport washer in upright position.

Plug into an earthed outlet.

Do not remove earth pin.

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,

or moving:

1. Refer to Installation Instructions to locate, level, and

connect washer.

2. Before using again, run washer through the following

recommended procedure:

To use washer again:

1. Flush water pipes and hoses. Reconnect water inlet

hoses. Turn on both water faucets.

2. Plug in washer or reconnect power.

3. Run washer through jeans cycle to clean washer and

remove any antifreeze. Use half the manufacturer's

recommended amount of detergent for a medium-size

load.