- ページ 9

洗濯機 Whirlpool 7410のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 7410 14 ページ。 7kg, 1400rpm, 6th sense washing machine with clean +, white wwdc 7410

Description of failure indications

Failure

indication

lights up

"Water tap closed"

"Clean pump"

Appliance has no or insufficient water supply. The "Start(Pause)" light blinks.

Check whether:

• Water tap is fully open and water supply pressure is sufficient.

• Kinks are present in the water inlet hose.

• Mesh filter of water inlet hose is blocked (see "Care and Maintenance".

• The water hose is frozen up.

• The safety valve inspection window of your water inlet hose is red

(provided your appliance has a water supply hose as shown on picture "D" -

see previous chapter "Care And Maintenance"); replace the hose by a new

one available through our After-Sales Service or your specialist dealer.

After problem has been removed, restart programme by pressing "Start(Pause)".

If the fault occurs again, contact our After-Sales Service (see next chapter).

Waste water is not pumped out. The appliance stops in the corresponding

programme step; unplug it and check whether:

• Kinks are present in the drain hose, or the hose is blocked for another reason.

• Filter or pump is blocked (see chapter ("Draining Residual Water/

Cleaning The Filter"); make sure the water has cooled before draining

the appliance).

• The drain hose is frozen up.

After problem has been removed, push the "Reset" button for at least 3 seconds;

afterwards restart the desired programme. If the fault occurs again, contact our

After-Sales-Service (see next chapter).

Description - Causes - Solutions

GB 9