- ページ 15
洗濯機 Whirlpool 7MWFW87HEDC0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 7MWFW87HEDC0 48 ページ。
ページを印刷する
NON=USE AND VACATION
CARE
Operate your washer only when you are home. If moving,
or not using your washer for a period of time, follow these
steps:
1. Unplug or disconnect
power to washer.
2. Turn off water supply to washer to avoid flooding due
to water pressure surges.
3. Clean the dispensers. See "Cleaning the Dispensers."
WINTER
STORAGE
CARE
iMPORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize
washer:
1. Shut off both water faucets, disconnect
and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in washer drum
and run washer on NORMAL cycle for about two
minutes to mix antifreeze and remaining water.
3. Unplug washer or disconnect
power.
TRANSPORTING
YOUR WASHER
1. Shut off both water faucets. Disconnect
and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect
drain hose from drain system and from back
of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer drum.
6. Bundle power cord with a rubber band or cable tie to
keep it from hanging onto the ground.
IMPORTANT: Call for service to install new transport
bolts.
Do not reuse transport bolts. Washer must be transported
in the upright position. To avoid structural damage to
your washer, it must be properly set up for relocation
by a certified technician.
f
REINSTALLING/USING
WASHER
AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended
procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
Electrical
Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
2. Plug in washer or reconnect power.
3. Run washer through HEAVY DUTY cycle to clean washer
and remove antifreeze, if used. Use only HE detergent.
Use half the manufacturer's
recommended
amount for a
medium-size
load.
15