- ページ 5

洗濯機 Whirlpool 8212638RPのPDF オーナーズマニュアル取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 8212638RP 29 ページ。

ページを印刷する

g. Touch and hold START/PAUSE to begin the cycle. The

Clean Washer with affresh

below.

NOTE: For best results, do not interrupt cycle.

Description of Clean Washer with affresh

1. The Clean Washer with affresh

clothing or other items are in the machine.

2. If no items are detected in the machine, it will proceed with the

cycle.

a. If any items are detected in the machine, "rL" (remove

load) will be displayed. The door will unlock. Open

machine and remove any garments from the machine

drum.

b. Touch POWER to clear the "rL" code.

c. Touch and hold START/PAUSE to restart the cycle.

3. Steam models only: During the first 20 minutes of the cycle,

it will activate the steamer but the drum will not spin or fill with

water. You may see condensation on the door window during

this initial phase. If you are using an affresh

tablet, it will not dissolve completely during the steam phase.

This is normal.

After the cycle is complete, leave the door open slightly to

allow for better ventilation and drying of the machine interior.

Cleaning the Dispensers

After using the Clean Washer with affresh

some residue buildup in the machine's dispensers.

To remove residue from the single load dispenser, remove the

drawer and wipe the surfaces with an affresh

Wipe or a damp cloth and towel dry either before or after you run

the Clean Washer with affresh

cleaner, if needed.

On some models: To remove residue from the Load & Go

dispenser, lift the handle on the dispenser housing and pull to

remove it from the machine cabinet; then rinse the dispenser

thoroughly with running water. Wipe the outside dispenser surface

with an affresh

Machine Cleaning Wipe or a damp cloth, and

towel dry. Use an all-purpose surface cleaner, if needed.

Replace the dispenser in the machine cabinet and make sure that

it is correctly seated.

NOTE: Dispensers are not dishwasher-safe.

Cleaning the Outside of the All-In-One Washer & Dryer

Use an affresh

Machine Cleaning Wipe or a soft, damp cloth or

sponge to wipe up any spills. Occasionally wipe the outside of

your machine to help keep it looking new. Use an affresh

Machine Cleaning Wipe or mild soap and water.

IMPORTANT: To avoid damaging the machine's finish, do not use

abrasive products.

Clean Washer Cycle Reminder

NOTE: Not all models have the Clean Washer with affresh

reminder light.

The Clean Washer with affresh

wash cycle when the machine has run 30 wash cycles. This is a

reminder to run the Clean Washer with affresh

If the Clean Washer with affresh

will stop flashing at the end of a wash cycle after running three

more regular wash cycles. After 30 more wash cycles are

completed, the Clean Washer with affresh

the end of a wash cycle as a reminder.

cycle operation is described

Cycle Operation:

cycle will determine whether

Washer Cleaner

cycle, you may find

Machine Cleaning

cycle. Use an all-purpose surface

LED will flash at the end of a

cycle.

cycle is not turned on, the LED

LED will again flash at

REMOVING THE DISPENSER

Single Load Dispenser Drawer

To remove:

1. Pull dispenser drawer out until it stops.

2. Press down on the release tab and pull straight out to remove

the dispenser.

3. Lift off cover panel by pulling straight up.

To replace:

1. Position cover panel back onto posts on dispenser. Apply

bulk

™

slight pressure on cover panel to seat it.

2. Align edges of dispenser with guides in machine; then slide

dispenser back into slot.

Cleaning Load & Go

models)

cycle

It is recommended that you rinse out the Load & Go

when refilling, when changing detergent types or concentrations,

or when the machine will not be used for an extended period.

1. Pull the dispenser drawer out until it stops.

2. Lift out the Load & Go

Containers (on some

™

containers.

™

containers