- ページ 8

洗濯機 Whirlpool 8212638RPのPDF オーナーズマニュアル取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 8212638RP 29 ページ。

INSTALLATION INSTRUCTIONS

WARNING

Excessive Weight Hazard

Use two or more people to move and install or uninstall

appliance.

Failure to do so can result in back or other injury.

NOTE: To avoid floor damage, set machine onto cardboard before

moving it.

Move All-In-One Washer & Dryer

It is necessary to remove all shipping materials for proper

operation and to avoid excessive noise from machine.

Move machine to within 4 ft (1.2 m) of its final location. It must be

in a fully upright position.

Locate transport bolts

Locate four transport bolts on rear of machine.

Remove transport bolts from All-In-One Washer &

Dryer

Loosen bolts with a 5/8" (16 mm) wrench. Slide each bolt and

spacer to center of hole.

Pull bolts and plastic spacers from back of machine. Discard bolts

and spacers.

NOTE: Do not plug machine in until installation has been

completed.

Tools needed:

Adjustable or open end

wrenches 1/2" (13 mm), 5/8"

(16 mm) and 9/16" (14 mm)

Ruler or measuring tape

Optional tool

Flashlight

Parts needed (not supplied with machine):

Water inlet hoses (2)

Parts supplied (not supplied with machine):

NOTE: All parts supplied for installation are in the machine

basket.

Cable tie

Level

Pliers that open to 1

(39.5 mm)

Bucket

Flat inlet hose washers (4)

Drain hose with clamp and

form (may be shipped

unassembled)