- ページ 7

洗濯機 Whirlpool 859991537390のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool 859991537390 19 ページ。

Whirlpool 859991537390 ユーザーマニュアル
User manual
OPTIONS
! If the selected function is incompatible with the set programme, the incompatibility will be signalled by a buzzer (3 beeps).
! If the selected function is incompatible with another previously set function the function will not be enabled.
START DELAY
To set the selected programme to start at a later time,
press the button to set the desired delay time. The symbol
lights on the display when this fuction is enabled. To
cancel the delayed start, press the button again untile the
value ‚''0'' is shown on the display.
FRESHCARE+
This option enhances washing performance by
generating steam to inhibit the proliferation of the main
bad odour sources inside the machine. After steam phase,
the washing machine will perform gentle tumbling through
slow rotations of the drum. FreshCare+ option starts after
the cycle ends for a maximum duration of 6h and you can
interrupt it at any time by pressing any button on control
panel or turning the knob. Wait around 5 minutes before
door can be opened.
FUNCTIONS
ON/OFF
To switch on the washing machine: press the
"ON/OFF"
button, the "Start/Pause"
To switch o the washing machine during the wash cycle,
press and hold the button for approximately 3 seconds. If
the button is pressed brie y or accidentally the machine will
not switch o .
To switch o the washing machine after programme end:
press the "ON/OFF"
button until the lights go o .
KNOB
To select and con rm programmes. Turn to
select.
START/PAUSE
To start the programme, after you have nished your
settings. To pause a running programme. To continue a
paused programme.
KEY LOCK
To lock the control panel, press and hold the
"Key lock"
button for approximately 3 seconds. The
symbol
will light up on the display to indicate that the
control panel has been locked (with the exception of the
"ON/OFF"
button). This prevents unintentional changes
to programmes, especially with children near the machine.
To unlock the control panel, press and hold the "Key lock"
button for approximately 3 seconds .
If you want to change the temperature, press the
"temperature"
want to change the spin speed, press the "Spin"
The value appears on the display.
BLEACHING
If you wish to bleach the laundry, load the washing machine
and set the "Rinse & Spin" programme
button light up.
Start the machine and wait for it to complete the rst water
lling cycle (roughly 2 minutes). Put the machine in pause
mode by pressing the "Start/Pause"
the detergent drawer and pour the bleach (observe the
recommended doses indicated on the package) into the
main wash compartment where the partition was previously
mounted. Restart the cycle by pressing the "Start/Pause"
button.
If desired, it is possible to add fabric softener into the
appropriate compartment of the detergent drawer.
DEMO MODE
This function is only used for sales presentations. By this
you can interact with washing machine and see it working
without water. To enter Demo mode, switch the washing
machine ON and OFF again. Press and hold "Start/Pause"
button and hold both buttons for 10 seconds.
To deactivate this function, switch the washing machine
OFF. Than press and hold "Start/Pause"
5 seconds press also "ON/OFF"
buttons for 2 seconds.
TEMPERATURE
Every programme has a prede ned temperature.
button. The value appears on the display.
SPIN
Every programme has a prede ned spin speed. If you
button, then within 5 seconds press also "ON/OFF"
EN
button.
.
button, open
button, within
button and hold both
7