- ページ 29

洗濯機 Whirlpool 8MWTW1844のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 8MWTW1844 41 ページ。

ページを印刷する

In order to reduce the danger at the minimum for

possible electric shocks, the cable must be plugged in

a grounded 3 prong outlet, according to the local

codes and standards. If there is not available an

equivalent outlet, it is responsibility and obligation of

the costumer to have a proper plug with grounded

connection installed by a qualified electrician.

If codes allow it and the ground wire connection is

separated, it is recommended that a qualified

electrician determines if the grounded connection is

adequate.

If you are not sure the ground connection of the

washer is the proper one, verify it with a qualified

electrician.

NOTE: If the electric cable is damaged, it must be replaced by

an original electric wire and the replacement must be made by

an electrician.

INSTALLATION INSTRUCTIONS

Risk of Excessive Weight

Use two or more persons to move and

install the washer.

Failure in following these instructions

may cause back injuries or other kind of

injuries.

Remove the package and take out the shipping base

Take out all shipping materials to get a proper function and

avoid excessive noise from the washer.

To avoid damages to the floor and washer, place the carton

corner protections on the floor, behind the washer. Lay the

washer down helped by another person and place it on the

carton corner protections (as shown). Remove the

transportation base. Put the washer in a vertical position.

IIMPORTANT: For a proper functioning it is needed to take out

the shipping base.

Remove cardboard packing tray from tub

Remove tape from washer lid, open the lid and take out the

cardboard packing tray from tub and set aside. Assure all

packaging components were removed before installing the

washer.

NOTE: Keep the part in case you need to move the washer

later.

Install the drain hose

6.1

6.2

.9m-1.2m

Fit the drain hose in the drainage according to the

installation.

6.1 Floor vertical pipe drain system

6.2 Wall vertical pipe drain system

6.3 Sink Drain system

For the above 3 types of installation, you must consider the

following issues:

Minimum diameter for vertical pipe draining: (5.1 cm)

Minimum draining capacity: 64 L per minute.

Hose must be placed to a height between 0.9 m and 1.2 m

from the floor. If it is placed at a lower height it may cause

the automatic drain.

IMPORTANT: There must not be more than 12 cm of draining

hose within the vertical pipe; do not force the excess of hose

within the vertical pipe, or place it in the sink bottom.

NOTE: Never remove bands located in the drain hose once

they are assembled in the washer rear panel, to avoid the

drain hose damage when using the cutting grippers. The

bands assembled in the rear panel, guarantee the correct

washer functioning.

Install filling hoses

ATTACHMENT WITH FILTER

TOWARDS WATER OUTTAKE

Before connecting the hoses let the water run for 10

seconds.

Clean at least once a month the filters, removing the

hoses and use a brush to eliminate the residuals. Verify

for leaks.

6.3

.9m-1.2m

YOU MAY USE TWEEZERS

TO INSTALL HOSES.