- ページ 14

洗濯機 Whirlpool 8MWTW2024のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 8MWTW2024 44 ページ。 Top-loading high efficiency washer
Whirlpool 8MWTW2024 にも：取扱説明書 (41 ページ)

ページを印刷する

WASHER MAINTENANCE

WATER INLET HOSES

Replace inlet hoses after 5 years of use to reduce the risk of hose

failure. Periodically inspect and replace inlet hoses if bulges,

kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, mark the date of replacement on

the label with a permanent marker.

CLEANING YOUR WASHER

Read these instructions before beginning the cleaning process

recommended below. This procedure of maintaining your washer

should be carried out at least once a month or each 30 wash

cycles, whichever comes first, to control the levels of dirt and

detergents that may accumulate in your washer.

Cleaning the washer interior

Cleaning the washer with afresh (some models)

This washing machine has a special cycle that uses high volumes

of water that in combination with the affresh washing machine

cleaner or chlorine bleach removes waste detergent, mold and

sediment that could accumulate inside the washing machines.

Keep your washer as clean and fresh as your clothes.

To keep washer interior odor-free, follow this recommended

monthly cleaning procedure:

Make sure the washer is empty.

Using recommended AFFRESH

tablet to washer drum or add 1 cup (250 mL) to the liquid

chlorine bleach dispenser.

IMPORTANT: Do not add detergent to the cleaning cycle with

afresh. Do not use more than recommended amount of bleach to

avoid damaging product over time.

Close washer lid.

Select Cleaning Using afresh (for some models) or Select the

cycle for Whites, Hot temperature and load size XG.

Press START/PAUSE button to start cycle.

NOTE: For best results, do not interrupt cycle. If cycle must be

interrupted, if it's mandatory to interrupt the cycle:

Pause the cycle.

Cancel the cycle and follow the next steps: Press and hold

the START/Pause button from 4 to 6 seconds to cancel the

cycle or press the START/Pause button and set the cycle

knob to Off for 3 seconds.

After the cycle has been interrupted, it is recommended to

run a rinse cycle (See selection of Manual stages) to remove

residual chlorine or affresh that may remain in the basket.

Cleaning your dispenser tray

Remove the dispenser drawer. To remove, open the drawer

completely and slightly pull upwards.

09-Feb-2018 07:28:55 EST | RELEASED

washer cleaner, add one

In some European factories the letter "W" of the part code mentioned herein will be automatically

CLEANING YOUR WASHER (continued)

Remove the siphon from the dispenser compartment for

fabric softener, pull upwards.

Rinse the dispenser and siphon under a stream of warm

water, wipe with a damp cloth to remove liquid fabric softener

residue and / or detergent, and then replace the fabric

softener siphon in place.

Clean the box where the dispenser drawer rests by wiping

with a damp cloth to remove detergent and/or softener.

Position the dispatcher drawer by pushing it slightly into the

box where it rests.

Cleaning the chlorine bleach tray

Clean the inside of the tray using a damp clean cloth.

Cleaning the fabric softener tray

(Applicable only for models with fabric softener dispenser on the

Pull container out, grab the upper side of the tray with your hands

and squeeze while you lift up slightly using your thumbs.

replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")

impeller)