- ページ 6

洗濯機 Whirlpool ATW4475VのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool ATW4475V 20 ページ。 Whirlpool atw4475v: user guide

5. Close the washer lid. Washer will not operate with lid open.

6. Select Load Size and Temperature Options.

7. Select Extra Rinse Option if desired.

8. Select Cycle.

Push the Cycle Control knob in and turn clockwise to the

cycle you want.

9. Start the washer by pulling out the Cycle control knob.

To stop at any time, push in the Cycle Control knob.

■

To restart, close the lid and pull out the Cycle Control knob.

■

WASHER CARE

Cleaning Your Washer

Use a soft, damp cloth or sponge to wipe up any spills such as

detergent or bleach from the outside of your washer.

Clean your washer interior by mixing 1 cup (250 mL) of chlorine

bleach and enough detergent to equal twice the manufacturer's

recommended amount for a normal wash load. Pour this mixture

into your washer and run it through a complete cycle using hot

water. Repeat this process if necessary.

Remove any hard water deposits using only cleaners labeled as

washer safe.

Water Inlet Hoses

This washer does not include water inlet hoses. The

manufacturer recommends use of factory specified parts. A

list of factory specified hoses available for separate purchase

is in the "Accessories" section of this book. These hoses

are manufactured and tested to meet the manufacturer's

specifications.

Replace inlet hoses after 5 years of use to reduce the risk of hose

failure. Periodically inspect and replace inlet hoses if bulges,

kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, mark the date of replacement

on the label with a permanent marker.

Moving and Storage

Because some water may stay in the hoses, freezing can damage

your washer. If storing or moving your washer during freezing

weather, winterize it.

Winterizing your washer

1. Shut off both water faucets. Disconnect and drain water inlet

hoses. Pour 1 qt (1 L) of R.V.-type antifreeze into the basket.

2. Run washer on a drain and spin setting for about 30 seconds

to mix the antifreeze and remaining water.

3. Unplug washer or disconnect power.