- ページ 2

洗濯機 Whirlpool AWM 6100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool AWM 6100 14 ページ。 Front load washing machine
Whirlpool AWM 6100 にも：サービスマニュアル (22 ページ)

ページを印刷する

BEFORE USING THE WASHING MACHINE

1.Remove the packaging and check

• After unpacking, make sure that the washing

machine is undamaged. If in doubt, do not use

the washing machine. Contact After-Sales

Service or your local retailer

• Check that the accessories and supplied parts are

all present

• Keep the packing material (plastic bags,

polystyrene parts, etc.) out of reach of children,

as they are potentially dangerous

2.Remove the transport bolts

• The washing machine is fitted with a transport

bolts to avoid any possible damage to the

interior during transport. Before using the

washing machine, it is imperative that the

transport bolts are removed

3.Install the washing machine

• Remove the protective foil from the control

panel

• Move the appliance without lifting it by the

worktop

• Install the appliance on a solid and level floor

surface, preferably in a corner of the room

• Make sure that all four feet are resting firmly on

the floor and check that the appliance is

perfectly level (use a spirit level)

4.Water inlet

• Connect the water supply inlet hose in

accordance with regulations of your local water

company

• Water inlet:

Cold water only

• Tap:

3/4" threaded hose connection

• Water Pressure

(flow pressure): 100-1000 kPa (1-10 bar)

5.Drain hose

• Connect the drain hose to the siphon or hook it

over the edge of a sink by means of the "U" bend

supplied

• If the washing machine is connected to a built-in

pumping out system, ensure that the latter is

equipped with a vent to avoid simultaneous

loading and draining of water (siphoning effect)

6.Electrical connections

• Electrical connections must be carried out by a

qualified technician in compliance with the

manufacturer's instructions and local safety

regulations

• Data concerning voltage, consumption and fuses

are located on the inside of the appliance door

• The appliance must be connected to the mains

exclusively by means of a socket with an earth

connection in accordance with established

regulations. The washing machine must be

earthed by law. The manufacturer declines all

liability for damage to property or injury to

persons or animals due to non-compliance with

the directions given above

• Do not use extension leads or multi sockets

• Before any maintenance on the washing

machine disconnect it from the mains supply

• Access to the mains plug or to disconnection

from mains supply via a double-pole switch must

be ensured at all times following the installation

• Do not operate the washing machine if it has

been damaged during transport. Inform the

After-Sales Service

• Mains cable replacement is only to be carried out

by After-Sales Service

• The washing machine must only be used in the

household for the prescribed uses

Minimum housing dimensions:

Width:

600 mm

Height:

825 mm

Depth:

600 mm