- ページ 20

洗濯機 Whirlpool CATALYSTのPDF トラブルシューティング＆修理マニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool CATALYST 45 ページ。 Electronic three-speed automatic washers with catalyst cleaning action
Whirlpool CATALYST にも：取扱説明書 (15 ページ)

ページを印刷する

ACCESSING COMPONENTS IN THE CONSOLE

Disconnect the power supply to the washer.

Remove the two (2) Phillips Head screws

securing the lower left and right rear corners

of the console to the washer top. (Fig. 2)

Tilt the console back on the hinges that

secure the top of the console to the washer

back.

All components in the console are now accessible for service.

Do not open the package containing the Electronic Printed Circuit Board until it is time to install it.

ESD may damage or weaken the electronic board.

•Use an anti-static wrist strap. Connect wrist strap to a green ground connection point or unpainted metal on the

appliance.

Touch your finger repeatedly to a green ground connection point or unpainted metal on the appliance.

•Avoid touching electronic parts or terminal contacts; handle the electronic board by the edges only.

Removing the Electronic Control Board

The Electronic Control Board is located in the center of the console area.

Disconnect the four (4) wiring harness plugs and two (2) ribbon connectors from the electronic

control board. (Fig. 3)

Remove the hex-head screw securing the electronic control board to the control bracket.

RIBBON

CONNECTORS

IMPORTANT SERVICING POINTS

Electrostatic Discharge (ESD) Sensitive Electronics

SCREW

WIRING

HARNESS

CONNECTORS

Fig. 2

SCREW

Fig. 3

WIRING

HARNESS

CONNECTOR