ページを印刷する
19504259100 English
Programmes
Programme
GB
Automatic Drying
(average loads)
Automatic Drying
(large loads)
Easy Iron
Timed Drying
(Up to 120 minutes)
Cool Tumble Phase
Easy Iron
Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which
fluffs the fibres of clothing that has been left in the same position/location for an extended period of time. The cycle
relaxes the fibres and makes them easier to iron and fold.
! Easy Iron is not a drying programme and should not be used for wet articles of clothing.
For best results:
1. Do not load more than maximum capacity. These numbers refer to dry weight:
Fabric:
Cotton and Cotton mix 2.5 kg
Synthetics
Denim
2. Unload the dryer immediately after the end of the drying cycle, hang, fold or iron the articles and put them
away in the closet. Should this not be possible, repeat the cycle.
The Easy Iron effect varies from one fabric to the next. It works very well on traditional fabrics like Cotton or
Cotton mix, and less well on acrylic fibres and on materials such as Tencel.
{PDF Created 13/11/04 12:27}
What it does
Dries completely: your clothes
are ready to be worn. For
Average loads (from 1 to 3 kg)
of Cotton
, polycotton, or
synthetics.
Dries completely: your clothes
are ready to be worn. For Large
loads (from 3 to 6 kg) of
Cotton.
Brief programme
(approximately 10 minutes) that
softens fibres of clothing that is
ready for ironing.
Dries wet clothing that will be
ironed, acrylic fibres
or
small loads (less than 1 kg).
Heating Elements turn
themselves off and clothing is
cooled down.
Max load:
2 kg
2 kg
How to set it
1.
Select HIGH HEAT
by pressing the HEAT
Button.
2.
Position the PROGRAMME knob on
3.
Press the start Button.
will turn on.
1.
Select HIGH HEAT
by pressing the HEAT
Button.
2.
Position the PROGRAMME knob on
3.
Press the start Button.
will turn on.
1.
Select HIGH HEAT
by pressing the HEAT Button.
2.
Position the PROGRAMME knob on
3.
Press the start Button.
. The ACTIVE light
will turn on.
1.
Select required Heat setting HIGH HEAT
or LOW HEAT
by pressing the HEAT
Button.
2.
Position the PROGRAMME knob on the
desired time.
3.
Press the start Button.
will turn on.
This is the programmes' final phase. Approximately
10 minutes before the finish, the knob advances
automatically to the Cool Tumble phase. After this the
Buzzer will sound (if selected) and the clothing is
ready to be taken out.
TD4011 Issue 1
Note
! If you select LOW HEAT,
this programme will not dry
your clothes. For Acrylic
fibres or small loads select
Timed Drying.
This programme can also
. The ACTIVE light
be used for large loads if
you require a slightly drier
result.
! If you select LOW HEAT,
this programme will not dry
your clothes. For Acrylic
fibres or small loads select
Timed Drying.
. The ACTIVE light
This programme can also
be used for average loads if
you prefer a damper result.
! This is not a drying
programme (see below)
Consult suggested drying times
(see Laundry)
. The ACTIVE light
Always allow the dryer to
complete this phase.