- ページ 16

冷蔵庫 Whirlpool ED5KVEXVLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool ED5KVEXVL 36 ページ。 Whirlpool ed2gvexvd: user guide
Whirlpool ED5KVEXVL にも：製品寸法 (1 ページ)

ページを印刷する

This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The

concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the

permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.

Substance Reduction

NSF Reduction

Aesthetic Effects

Requirements

Chlorine Taste/Odor

50% reduction

Particulate Class I

85% reduction

Contaminant

NSF Reduction

Reduction

Requirements

Lead: @ pH 6.5

0.010 mg/L

Lead: @ pH 8.5

0.010 mg/L

Mercury: @ pH 6.5

0.002 mg/L

Mercury: @ pH 8.5

0.002 mg/L

Benzene

0.005 mg/L

O-Dichlorobenzene

0.6 mg/L

Toxaphene

0.003 mg/L

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).

Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters).

It is essential that operational, maintenance, and filter

replacement requirements be carried out for the product to

perform as advertised.

Use replacement filter P2RFWG2, part #4396841.

2008 suggested retail price of $39.99 U.S.A./$54.95 Canada.

Prices are subject to change without notice.

Model P1WG2L/P1WG2: Style 1 – When the filter indicator

reads 10%, order a new filter. When the indicator reads 0%, it is

recommended that you replace the filter.

Style 2 – When the filter indicator changes from green to yellow,

order a new filter. When the indicator changes from yellow to red,

it is recommended that you replace the filter.

Style 3 – When the water filter status display changes from

"GOOD" to "ORDER," order a new filter. When the filter indicator

reads "REPLACE," it is recommended that you replace the filter.

Style 4 – Press FILTER to check the status of your water filter. If

the filter indicator light is yellow, order a new filter. If the filter

indicator light is red, it is recommended that you replace the filter.

Change the water filter cartridge every 6 months. If the water

flow to the water dispenser or ice maker decreases noticeably

before 6 months have passed, replace the water filter cartridge

more often.

Class I particle size: >0.5 um to <1 um

Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.

® NSF is a registered trademark of NSF International.

Base Grille Water Filtration System

Model P1WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters)

Model P1WG2/P2RFWG2 Capacity 200 Gallons (757 Liters)

System tested and certified by NSF International against NSF/ANSI

Standard 42 for the reduction of Chlorine Taste and Odor, Particulate

Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead,

Mercury, Benzene, Toxaphene, and O-dichlorobenzene.

Average

Influent Challenge

Influent

Concentration

1.909 mg/L

2.0 mg/L ± 10%

5166666 #/mL

At least 10,000 particles/mL

Average

Influent Challenge

Influent

Concentration

143.33 ug/L

0.15 mg/L ± 10%

150 ug/L

0.15 mg/L ± 10%

0.0058 mg/L

0.006 mg/L ± 10%

0.00646 mg/L

0.006 mg/L ± 10%

0.015 mg/L

0.015 mg/L ± 10%

1.83333 mg/L

1.8 mg/L ± 10%

0.016 mg/L

0.015 mg/L ± 10%

Maximum

Average

Effluent

0.05 mg/L

<0.05 mg/L

4200 #/mL

1900 #/mL

Maximum

Average

Effluent

1.0 ug/L

0.3 ug/L

0.0002 mg/L

0.8 ug/L

0.0004 mg/L

0.5 ug/L

0.0005 mg/L >96.7

160 ug/L

0.005 mg/L

1 ug/L

0.001 mg/L

These contaminants are not necessarily in your water supply.

While testing was performed under standard laboratory

conditions, actual performance may vary.

The product is for cold water use only.

Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after the

system.

Refer to the "Warranty" section for the Manufacturer's name,

address and telephone number.

Refer to the "Warranty" section for the Manufacturer's limited

warranty.

Application Guidelines/Water Supply Parameters

Water Supply

Water Pressure

Water Temperature

Service Flow Rate

Minimum %

Average %

Reduction

>97.4

>99.9

Minimum %

Average %

Reduction

>99.3

99.3

94.8

96.4

88.5

94.9

>96.7

91.1

96.5

>93.8

City or Well

30 - 120 psi (207 - 827 kPa)

33° - 100°F (0.6° - 37.8°C)

0.5 gpm (1.9 Lpm) @ 60 psi