- ページ 12

冷蔵庫 Whirlpool GSC25C6EYBのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Whirlpool GSC25C6EYB 44 ページ。 Sxs xxl refrigerators water filter housing/door misaligned
Whirlpool GSC25C6EYB にも：製品寸法 (1 ページ), エネルギー・マニュアル (2 ページ), テクニカル・サービス・ポインタ (4 ページ)

ページを印刷する

This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The

concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the

permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.

Substance Reduction

NSF Reduction

Aesthetic Effects

Requirements

Chlorine Taste/Odor

50% reduction

Particulate Class I

85% reduction

Contaminant

NSF Reduction

Reduction

Requirements

Live Cysts

†

99.95%

Asbestos

99%

Lead: @ pH 6.5

0.010 mg/L

Lead: @ pH 8.5

0.010 mg/L

Lindane

0.0002 mg/L

Toxaphene

0.003 mg/L

Atrazine

0.003 mg/L

2,4 - D

0.07 mg/L

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).

Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters).

It is essential that operational, maintenance, and filter

replacement requirements be carried out for the product to

perform as advertised.

Use replacement filter P4RFWB, part #W10295370.

2011 suggested retail price of $39.99 U.S.A./$49.99 Canada.

Prices are subject to change without notice.

Style 1 – When the water filter status display changes from

"GOOD" to "ORDER," order a new filter. When the filter indicator

reads "REPLACE," it is recommended that you replace the filter.

Style 2 – When the filter indicator changes from green to yellow,

order a new filter. When the indicator changes from yellow to red,

it is recommended that you replace the filter.

Style 3 – When the filter indicator reads 10%, order a new filter.

When the indicator reads 0%, it is recommended that you

replace the filter.

Style 4 – Press FILTER to check the status of your water filter. If

the filter indicator light is yellow, order a new filter. If the filter

indicator light is red, it is recommended that you replace the filter.

After changing the water filter, flush the water system. See

"Water and Ice Dispensers" or "Water Dispenser."

These contaminants are not necessarily in your water supply.

While testing was performed under standard laboratory

conditions, actual performance may vary.

The product is for cold water use only.

Class I particle size: >0.5 to <1 um

Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.

†

Based on the use of Cryptosporidium parvum oocysts

††

Fibers greater than 10 um in length

® NSF is a registered trademark of NSF International.

PERFORMANCE DATA SHEET

Water Filtration System

Model P5WB2L/P4RFWB Capacity 200 Gallons (757 Liters)

System tested and certified by NSF International against NSF/ANSI

Standard 42 for the reduction of Chlorine Taste and Odor, and Particulate

Class I*; and against NSF/ANSI Standard 53 for the reduction of Live

Cysts, Asbestos, Lead, Lindane, Toxaphene, Atrazine, and 2,4 - D.

Average

Influent

2.0 mg/L

7,300,000 #/mL

Average

Influent

160,000/L

87 MFL

0.160 mg/L

0.140 mg/L

0.0019 mg/L

0.014 mg/L

0.0094 mg/L

0.220 mg/L

Influent Challenge

Concentration

2.0 mg/L ± 10%

At least 10,000 particles/mL

Influent Challenge

Concentration

50,000/L min.

††

to 10

fibers/L

0.15 mg/L ± 10%

0.002 mg/L ± 10%

0.015 mg/L ± 10%

0.009 mg/L ± 10%

0.210 mg/L ± 10%

The water system must be installed in compliance with state and

local laws and regulations.

Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after the

system. Systems certified for cyst reduction may be used on

disinfected waters that may contain filterable cysts.

Refer to the "Warranty" section for the Manufacturer's name,

address and telephone number.

Refer to the "Warranty" section for the Manufacturer's limited

warranty.

Application Guidelines/Water Supply Parameters

Water Supply

Water Pressure

Water Temperature

Service Flow Rate

Maximum

Minimum %

Effluent

Reduction

0.20 mg/L

75,000 #/mL

Maximum

Minimum %

Effluent

Reduction

54/L

†

99.97

0.17 MFL

0.001 mg/L

99.4

0.005 mg/L

98.6

0.00002 mg/L

98.9

0.001 mg/L

0.0005 mg/L

94.5

0.028 mg/L

87.5

City or Well

30 - 120 psi (207 - 827 kPa)

33° - 100°F (0.6° - 37.8°C)

0.5 gpm (1.9 Lpm) @ 60 psi

Average %

Reduction

97.2

99.4

Average %

Reduction

99.99

99.4

98.6

94.7

96.1