- ページ 6

冷蔵庫 Whirlpool 2300261のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 2300261 40 ページ。 Bottom-mount refrigerator

ページを印刷する

6. Fasten shutoff valve to cold water pipe with pipe clamp. Be

sure outlet end is solidly in the

pipe and that rubber washer is under the pipe clamp. Tighten

packing nut. Tighten the pipe clamp screws slowly and

evenly so rubber washer makes a watertight seal. Do not

overtighten or you may crush the copper tubing, especially if

soft (coiled) copper tubing is used. Now you are ready to

connect the copper tubing.

7. Slip compression sleeve and compression nut on copper

tubing as shown. Insert end of tubing into outlet end squarely

as far as it will go. Screw compression nut onto outlet end

with adjustable wrench. Do not overtighten.

8. Place the free end of the tubing into a bucket or sink. Turn ON

main water supply and flush out tubing until water is clear.

Turn OFF shutoff valve on the water pipe. Check for leaks.

Coil copper tubing.

Connect to Refrigerator

1. Remove plastic cap from water valve inlet port. Attach the

copper tube to the valve inlet using a compression nut and

sleeve as shown. Tighten the compression nut. Do not

overtighten. Confirm copper tubing is secure by pulling on

copper tubing.

2. Create a service loop using extreme care to avoid kinks.

Secure copper tubing to refrigerator cabinet with a "P"

clamp.

A. Copper tubing

B. "P" clamp

C. Compression nut

3. Turn on water supply to refrigerator and check for leaks.

Correct any leaks.

" drilled hole in the water

D. Compression sleeve

E. Water valve inlet port

Complete the Installation.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

Plug in refrigerator or reconnect power.

Base Grille

Remove the Base Grille

1. Grasp the grille with both hands.

2. Pull the grille toward you.

Replace the Base Grille

1. See the markings on the inside of the base grille for proper

placement.

2. Align the grille mounting clips with the cabinet slots.

3. Push the grille firmly into the cabinet slots until it snaps into

place.