- ページ 3

冷蔵庫 Whirlpool 2318508のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Whirlpool 2318508 40 ページ。 Whirlpool corporation refrigerator use & care guide refrigerator use & care guide

ページを印刷する

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

NOTE: Make sure the refrigerator is plugged into a grounded

3 prong outlet.

The control panel is located in the top of the refrigerator

compartment. To view or adjust the controls, push up on the

control panel and release.

For your convenience, your refrigerator controls are preset at the

factory. When you first install your refrigerator, make sure that the

controls are still preset to the mid-settings as shown.

IMPORTANT:

The refrigerator control adjusts the refrigerator compartment

temperature. The freezer control adjusts the freezer

compartment temperature.

The displays normally show the actual temperature inside the

refrigerator and freezer. For information on displaying set point

temperatures, see "Viewing Set Points."

Wait 24 hours before you put food into the refrigerator. If you

add food before the refrigerator has cooled completely, your

food may spoil.

NOTE: Adjusting the refrigerator and freezer controls to a

lower (colder) setting will not cool the compartments any

faster.

REFRIGERATOR USE

Using the Controls

Turning Refrigerator On

If the refrigerator is not on, press COOLING ON/OFF to turn

the cooling on.

To turn your refrigerator off, press COOLING ON/OFF. Your

refrigerator will not cool when the control is set to Off.

NOTE: Pressing the Cooling On/Off button does not

disconnect power to the refrigerator. The interior lights will

turn off if either compartment door is open for more than

10 minutes. Simply close and open the door to turn on the

interior lights.

Viewing Set Points

The factory recommended set points are 0°F (-18°C) for the

freezer and 37°F (3°C) for the refrigerator.

Set point range for the freezer: -6° to 6°F (-21°C to -14°C)

Set point range for the refrigerator: 32° to 46°F (0°C to 8°C)

To view the set point temperatures, press either the up or down

button for the refrigerator or freezer temperature. The display will

become brighter to indicate that you are viewing the set points.

Five seconds after an adjustment is made, the display lights will

dim and return to the actual temperature.

NOTE: During automatic defrost cycles, the actual temperature

displayed may be higher than the set point. This is normal. The

actual temperatures should return to the set points within a few

hours following completion of the defrost cycle.

Adjusting Controls

The mid-settings indicated in the previous section should be

correct for normal household refrigerator usage. The controls are

set correctly when milk or juice is as cold as you like and when ice

cream is firm.

If the temperature is too warm or too cold in the refrigerator or

freezer, first check the air vents to be sure they are not blocked.

If you need to adjust temperatures, use the settings listed in the

chart below as a guide. Wait at least 24 hours between

adjustments.

CONDITION/REASON:

REFRIGERATOR too warm

FREEZER too warm/too little ice

REFRIGERATOR too cold

FREEZER too cold

ADJUSTMENT:

REFRIGERATOR

Control 1° lower

FREEZER Control 1°

lower

REFRIGERATOR

Control 1° higher

FREEZER Control 1°

higher